• State TI Thinks Resolved
  • Locked Locked
  • Replies 5 replies
  • Answers 3 answers
  • Subscribers 18 subscribers
  • Views 407 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TXB0104-Q1: [TXB0104QRUTRQ1] Circuit review request

MJ Jeon
Genius 5240 points
Part Number: TXB0104-Q1
Other Parts Discussed in Thread: TXU0304-Q1, TXU0104-Q1, TXU0204-Q1

Hi, TI Support Team

TXB0104-Q1 product will be applied, and the circuit will be configured as shown in the figure below.

Please review.

Please advise if there are other considerations other than the CAP of the power stage.

Thanks.

Regards,

MJ

  • 0
    Guru 257000 points

    There are several import considerations (see sections 8.3.2/8.3.3/8.3.5 of the datasheet). This schematic does not show what is connected to the I/Os, so I cannot determine if it will work.

    When you have unidirectional signals, you should use the TXU0104-Q1/TXU0204-Q1/TXU0304-Q1 instead.

  • 0 in reply to Clemens Ladisch
    Genius 5240 points

    Hi, Clemens

    Thank you for your reply.

    Your inquiry has been described in the circuit diagram as follows.

    Please review again.

    In addition, which item is the most suitable for unidirectional?

    I appreciate your review comments.

    Thanks.

    Regards,

    MJ

  • 0 in reply to MJ Jeon
    Guru 257000 points

    You have 3 signals from 1.8 V to 3.3 V, and 7 signals from 3.3 V to 1.8 V. This can be handled with 3x TXU0304-Q1, with VCCA = 3.3 V and VCCB = 1.8 V.

  • 0 in reply to Clemens Ladisch
    Genius 5240 points

    Hi, Clemens

    The TXU0304-Q1 product is a fixed-direction product.

    As you can see from the circuit diagram, it is judged that the stability of the signal is better if the UART, PCM, and ON/OFF signals are driven by each IC.

    If you configure the circuit as you recommended, the applied signals will overlap. Is there any reason you recommended this part?

    TXB0104-Q1 is a bi-direction product, is there any problem with this product?

    Please advise.

    Thanks.

    Regards,

    MJ

  • 0 in reply to MJ Jeon
    Guru 257000 points

    Using only the TXU0304-Q1 simplifies the BOM.

    If you do want to separate these signals, you can use any combination of TXU devices, i.e., TXU0204-Q1 for U6, TXU0304-Q1 for U10, any any TXU for U12.

    The TXB has many potential problems; see sections 8.3.2/8.3.3/8.3.5 of the datasheet.