Part Number: DK-TM4C129X
Hi Team,
Our customer is using the DK-TM4C129X to upgrade the firmware of TM4C1297NCZAD13 as shown in the pictures below.
I understand from the E2E thread below that there are no plans to rebuild the the DK-TM4C129X.
Our customer is considering similar low cost evaluation board with In-Circuit Debug Interface (ICDI) such as EK-TM4C1294XL Launchpad to load the firmware to TM4C1297NCZAD13. However, the 10-pin connector in EK-TM4C1294XL is 2x5 whereas in DK-TM4C129X it's 1x10. It seems that the customer have to build their own cable to fit their existing board and the ICDI of EK-TM4C1294XL Launchpad. Can you please confirm if the EK-TM4C1294XL Launchpad can program TM4C1297NCZAD13?
Regards,
Danilo