UNABLE TO GENERATE A .BIN FILE

Prashantkumar Singh

Hello,

I am using CCSv5 for stellaris-LM3s818 target board.

I am able to build my project but i am only getting .out file being generated . I am not getting any .bin file being generated in debug folder. I need .bin file as i am using LM Flash programmer.

Can u please let me know the procedure.

Following commands are included in post-build steps:

"${CCE_INSTALL_ROOT}/utils/tiobj2bin/tiobj2bin" "${BuildArtifactFileName}" "${BuildArtifactFileBaseName}.bin" "${CG_TOOL_ROOT}/bin/ofd470" "${CG_TOOL_ROOT}/bin/hex470" "${CCE_INSTALL_ROOT}/utils/tiobj2bin/mkhex4bin"

Am I missing any further settings

Reply,

Thanks

over 9 years ago

0 Amit Ashara over 9 years ago

TI__Guru**** 244380 points

Hello Prashantkumar,

Please ensure that the commands are all in a single line. Last time around I had one of them in another line in post-build steps and the bin file did not get generated.

Regards

Amit

0 Markel Robregado over 9 years ago

Guru 85825 points

Prashantkumar Singh said:
hex470

Replace this with either armofd or armhex.

- kel

0 Amit Ashara over 9 years ago in reply to Markel Robregado

TI__Guru**** 244380 points

Thanks Kel. It would be a replacement for both ofd470 and hex470 if the same are not there in the CG_TOOL_ROOT.

"${CCE_INSTALL_ROOT}/utils/tiobj2bin/tiobj2bin" "${BuildArtifactFileName}" "${BuildArtifactFileBaseName}.bin" "${CG_TOOL_ROOT}/bin/armofd" "${CG_TOOL_ROOT}/bin/armhex" "${CCE_INSTALL_ROOT}/utils/tiobj2bin/mkhex4bin"

Regards

Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

UNABLE TO GENERATE A .BIN FILE