Other Parts Discussed in Thread: HALCOGEN
Hi everybody,
I'm facing problems working with TMDS570LS31 HDK (in fact same Problems with two boards...) and things seem to get worse day by day:
After powerup, the uC sometimes doesn't seem to run correctly (looking at LEDs or using a scope on some GPIOs that should toggle). Repeating the powerup procedure severel times I usually get it to work some time.
With attached on board XDS100 and "active" problem, I get the message "Suspended - Cross-triggering" and I cannot debug the program.
What does "cross triggering" mean here and how can I avoid and get the system working?
Problem seems to be independant of CCS, CGT, HALCoGen versions and also occures with TI examples out of the box.
Regards,
Ralph