RM48L730: errata sheet ( DCC issue )

Ratid

Part Number: RM48L730

Hi,

I want to use DCC module in one shot mode and am using the example provided in [SPNA211] application note.

does this application note take in account the advisory "DCC#24 Single Shot Mode Count may be Incorrect" mentioned in erratasheet [spnz196g] ?

Thank you!

over 6 years ago

0 Sunil Oak over 6 years ago

TI__Mastermind 49120 points

Hi,

SPNA211 describes the use of DCC to continuously monitor a clock signal using a reference clock signal. The erratum DCC#24 only applies to single-shot measurements using the DCC.

0 Ratid over 6 years ago in reply to Sunil Oak

Prodigy 210 points

Dear Sunil, Thank you for reply

DCC is used in "PLL Advisory SSWF021#45 Workaround " in one shot mode. (application note spna233).
does it take in account the advisory DCC#24 ? or there is no need to apply a workaround for this issue ?

thank you?

0 Sunil Oak over 6 years ago in reply to Ratid

TI__Mastermind 49120 points

The routine shown in the SSWF021#45 workaround document does not use the suggested workaround for DCC#24 (no multiple frequency measurements to identify and discard outliers). I will check with the subject matter expert to see if there are any plans to update the workaround for SSWF021#45.

Arm-based microcontrollers

Arm-based microcontrollers forum

RM48L730: errata sheet ( DCC issue )