DRV8301-69M-KIT: Lab02b cannot run with encryption.

The issue should be from the RAM assignment in your project. Please post the .cmd file.

Hi Yanming:

When testing encryption, I use the original routine to test

In other words, except for modifying the values of several flag bits in the routine(Which I mentioned in this post), I haven't modified other places. In other words, the cmd file is still the original flash.cmd file.

Best regards,

Keng

How do you implement and test encryption? Could you please provide more information about the operation steps or changes you did?

Hi Yanming:

No other changes have been made other than those mentioned in the original post.

The encryption method is encrypted by changing the password in the debug mode of CCS: Tools - On-chip flash.

After encryption by the above method, only LD2 flashes after power-on, but the motor cannot rotate.

Does the lab run well in flash without encryption? Do you connect the JTAG debugger on the board? Do you disconnect the on-board JTAG debugger by setting the switch? And set the boot mode to Flash as well?

1,

Yanming Luo said:

Does the lab run well in flash without encryption?

Yes, the lab run well in flash(without JTAG connected) without encryption.

2, 

Yanming Luo said:

Do you connect the JTAG debugger on the board?

Whatever I connect the JTAG debugger on the board or not, the motor can not spin with encryption. 

Even in the case of online flash debugging, the motor can't spin while the LD2 blink well. 

3, 

Yanming Luo said:

Do you disconnect the on-board JTAG debugger by setting the switch? And set the boot mode to Flash as well?

Yes, I have disconnected the on-board JTAG debugger by setting the SW3: 1 OFF and set the boot mode to flash by setting the SW1 all ON.

By the way, I think this may not be a HW setting problem? Because under the same HW setting, the KIT can run well without encryption. Only after encryption, the motor does not turn and LD2 blinks normally.