This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMDSCNCD28388D: DCAN configuration

Part Number: TMDSCNCD28388D
Other Parts Discussed in Thread: C2000WARE

I have tried running the c28x_CAN_comm model by following the steps given in this document: https://in.mathworks.com/help/ti-c2000/ug/ecan-example.html. I am currently using a TMDSCNCDF28388D control card and I am aware that this particular board hosts only a DCAN and MCAN module but no eCAN module. Although the Matlab blocks specify that they are eCAN type. What do I do if I need to configure my DCAN module on my microcontroller? I am assuming that this is the issue as there is no activity visible either on the Rx, Tx pins, or on the PCAN-View software. The model is being built successfully as shown in the screenshot below: