TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
C2000™︎ microcontrollers

C2000™︎ microcontrollers

C2000 microcontrollers forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) C2000™ microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search C2000™ microcontroller content or ask technical support questions on our families of real-time control MCUs. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] CLA: Does the CLA have access to all of the memory on the device?

    Lori Heustess
    Lori Heustess
    Q: Does the CLA have access to all of the memory on the device?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] CLA: Which peripheral registers can the CLA access directly?

    Lori Heustess
    Lori Heustess
    Q: Which peripheral registers can the CLA access directly?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] CLA: is the CLA only interrupt driven?

    Lori Heustess
    Lori Heustess
    Q: is the CLA only interrupt driven?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] CLA: Is the CLA programmable in C?

    Lori Heustess
    Lori Heustess
    Q: Is the CLA programmable in C?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] CLA: Is the CLA independent from the C28x CPU? Can they be synchronized?

    Lori Heustess
    Lori Heustess
    Q: Is the CLA independent from the C28x CPU? Can they be synchronized?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] CLA: Frequently Asked Questions

    Lori Heustess
    Lori Heustess
    Q: Where can I find answers to frequently asked questions related to the CLA? Note: this FAQ is currently a work in progress!!
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] F05: What is depletion?

    Lori Heustess
    Lori Heustess
    Other Parts Discussed in Thread: C2000WARE Q: What is depletion?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] F05 Flash: What do the operations erase and program do?

    Lori Heustess
    Lori Heustess
    Other Parts Discussed in Thread: C2000WARE Q: What do the operations erase and program do?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] F05 Flash: What is a sector?

    Lori Heustess
    Lori Heustess
    Q: What is a flash sector? Where are they documented?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
  • [FAQ] F05: Why can't I set more than 2 breakpoints in flash?

    Lori Heustess
    Lori Heustess
    Q: Why can't I set more than 2 breakpoints in flash? Why can't I single step code in flash?
    • Answered
    • over 6 years ago
    • C2000™︎ microcontrollers
    • C2000 microcontrollers forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    LAUNCHXL-F28379D: Optimization settings not working properly 0 Locked

    196 views
    1 reply
    Latest 8 months ago
    by Jason Osborn
  • Answered

    TMS320F280049C: TMS320F280049C 0 Locked

    137 views
    1 reply
    Latest 8 months ago
    by Jason Osborn
  • Suggested Answer

    TMS320F28035: F28035 SPI issue a certain delay (us) between the two times/Command, and the CS bus will be abnormally pulled high 0 Locked

    190 views
    3 replies
    Latest 8 months ago
    by Jason Osborn
  • Suggested Answer

    TMS320F28P559SJ-Q1: When the pin size is 0.13~0.23mm, the spec recommends a package pad of 0.2mm, that is, the pad width is less than the maximum tolerance of the pin. 128Pin (0.4mm pin pitch). . Will it cause cold soldering and displacement during PCB lay 0 Locked

    270 views
    4 replies
    Latest 8 months ago
    by MatthewPate
  • Answered

    TMS320F28027F: TMS320F28027with DRV8301 to run bldc motor 0 Locked

    684 views
    34 replies
    Latest 8 months ago
    by Genatco
  • Not Answered

    TMS320F2812: Issue when flash the firmware through SCI using C2Prog 0 Locked

    194 views
    3 replies
    Latest 8 months ago
    by Chanh Nguyen64
  • Not Answered

    TMS320F28379D: Bitrate mismatch 0 Locked

    109 views
    0 replies
    Started 8 months ago
    by Deepan V
  • Answered

    TMS320F28375S: Issue with SysCtl_setEMIF1ClockDivider after Upgrading to C2000Ware 5.4.0.00 0 Locked

    186 views
    1 reply
    Latest 8 months ago
    by Aswin P
  • Suggested Answer

    TMS320F280039C: When I use the flash_cmd file, the time of the delay_us() function increases. 0 Locked

    321 views
    9 replies
    Latest 8 months ago
    by Ozino Odharo
  • Answered

    F29H85X-SOM-EVM: Is it possible that single core examples download to core CPU3 and run directly 0 Locked

    248 views
    4 replies
    Latest 8 months ago
    by zou qingquan
  • Answered

    TIDM-02000: PSFB DCDC converter operation 0 Locked

    261 views
    4 replies
    Latest 8 months ago
    by sangmo kim
  • Not Answered

    LAUNCHXL-F28P65X: N/A 0 Locked

    88 views
    0 replies
    Started 8 months ago
    by Tyler Hawkins
  • Not Answered

    TMS320F28384D: One Shot ADC SOC Trigger 0 Locked

    115 views
    1 reply
    Latest 8 months ago
    by Sumit Patil1
  • Not Answered

    TMS320F28388D: AES-3 User data via counter from CLB counters 0 Locked

    203 views
    3 replies
    Latest 8 months ago
    by Luke Jones
  • Answered

    TMDSCNCD28P65X: SCIFLR overrun bit error set 0 Locked

    327 views
    6 replies
    Latest 8 months ago
    by Delaney Woodward
  • Not Answered

    TMS320F280038C-Q1: how to provide valid password after activating JTAGLOCK 0 Locked

    518 views
    11 replies
    Latest 8 months ago
    by Luke Jones
  • Not Answered

    TMS320F28069M: TMS320F28069M: Device Held in Reset Mode – Troubleshooting Steps? 0 Locked

    238 views
    3 replies
    Latest 8 months ago
    by Prarthan Bhatt
  • Not Answered

    TMS320F280039C-Q1: Why the global variable be initialized after CPU reset? 0 Locked

    167 views
    1 reply
    Latest 8 months ago
    by Prarthan Bhatt
  • Not Answered

    TMS320F28377D: I want to know the difference between pull-up enabled and non-pull-up when GPIO is set to output mode. 0 Locked

    287 views
    1 reply
    Latest 8 months ago
    by Prarthan Bhatt
  • Not Answered

    TMS320F28388D: My FSI counting datas are same. (succeed: 64%, fail(same numbers) : 36%) 0 Locked

    208 views
    4 replies
    Latest 8 months ago
    by Susmitha Bumadi
<>