CCS/MSP430FR4133: How to Configure MSP430FR4133 and CC1120 RF Module

Vivek Karunakaran

Part Number: MSP430FR4133
Other Parts Discussed in Thread: CC1120

Tool/software: Code Composer Studio

Hollo guys I have Msp430fr4133 and CC1120 Rf board,But i dont knw how to configure this two boards.please help me and give Some example codes.

over 7 years ago

0 Nathan Siegel over 7 years ago

TI__Genius 10980 points

Hi,

There a few different ways to do this, and they all involve establishing a serial connection between the two devices, such as UART or SPI. For some example code, see the "Tools and software" tab on the CC1120 product page.

Additionally, please see the following document, which shows an implementation using UART. Note that it doesn't include a software configuration for the MSP4304133 specifically, but it can easily be ported to that device.

www.ti.com/.../getliterature.tsp

Regards,
Nathan

0 Vivek Karunakaran over 7 years ago in reply to Nathan Siegel

Prodigy 60 points

it is working but i have error in this file hal_board.c

BCSCTL1 = CALBC1_1MHZ; // Set range
DCOCTL = CALDCO_1MHZ;
BCSCTL2 &= ~(DIVS_3); // SMCLK = DCO = 1MHz

0 Nathan Siegel over 7 years ago in reply to Vivek Karunakaran

TI__Genius 10980 points

Hi,

Are you using the project referenced in the document I linked to? I do not see that a hal_board.c in that project. Also, could you please detail what the error is?

Regards,
Nathan

0 Nathan Siegel over 7 years ago in reply to Vivek Karunakaran

TI__Genius 10980 points

Hi,

Has this issue been resolved? If there is no response soon this thread will be closed due to inactivity.

Regards,
Nathan

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS/MSP430FR4133: How to Configure MSP430FR4133 and CC1120 RF Module