MSP430FR2633: displaying channel data in captivate design center

Gourav H

Part Number: MSP430FR2633
Other Parts Discussed in Thread: CAPTIVATE-BSWP

Hello, I am a new bee to captivate technology. I have followed the steps from the CapTIvateDesignCenter_1.60.00.00 and also from the training video [https://training.ti.com/captivate-training-series-part3] but it doesn't seems to help me. I am working with captivate-bswp, The issue i am getting here is unable to display channel data in captivate design center even though it shows hid device connected.

over 7 years ago

0 Gary Gao over 7 years ago

TI__Mastermind 38665 points

Hi Gourav

Are you using the official demo code for BSWP? Which you can down load form:
software-dl.ti.com/.../index_FDS.html

0 Dennis Lehman over 7 years ago

TI__Guru 68151 points

Hi Gourav,

The default demo code for the BSWP uses the wake-on-proximity feature to keep the MSP in low power mode until you touch the BSWP panel. As long as you are touching the panel you should see data going to the design center. After you remove your hand data will continue for about 2 seconds, then the MSP enters low power mode.

0 Gourav H over 7 years ago in reply to Gary Gao

Intellectual 920 points

Yes

0 Gourav H over 7 years ago in reply to Gourav H

Intellectual 920 points

Thanks for the info.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430FR2633: displaying channel data in captivate design center