DRV8343H-Q1EVM: Can you break the software on the DRV8343H-Q1EVM

Salvatore Rouse

Part Number: DRV8343H-Q1EVM

I flashed the DRV board with the independent driver code and now the board will not connect to the GUI. Is there a way that I could either reset the board or reflash the firmware to fix this issue?

over 2 years ago

0 Andrew Liu over 2 years ago

TI__Mastermind 18916 points

Hi Salvatore,

Our team will review this question & aim to provide you a response by early next week

Best Regards,
Andrew

0 Aaron Barrera over 2 years ago in reply to Andrew Liu

TI__Mastermind 26046 points

Hi Salvatore,

Please ensure you are connecting the DRV8343H-Q1EVM to the GUI by following the correct power up sequence in the step-by-step User's Guide. Follow section 2.2.

If you have more than one USB port, try connecting the EVM to each one to see if it connects, sometimes the FTDI driver recognizes the wrong port.

Also ensure your FTDI driver is up to date: https://ftdichip.com/drivers/

Thanks,
Aaron

Motor drivers

Motor drivers forum

DRV8343H-Q1EVM: Can you break the software on the DRV8343H-Q1EVM