DRV8353RS-EVM: Code compilation process in CCS using Motorware

Dear TI Team,

As we are started with DRV8353RS-EVM based Motor Controller for initial motor spinning, if it getting success we would proceed with same driver IC and Microcontroller part for our development.

Firstly, I installed CCS, C2000ware, Motorware tools from TI website and same as the software for the EVM board also gathered from same TI website.

As per the User guide of DRV8353RS-EVM, I have extracted the code file DRV8353Rx-1.0.1.

(D:\ti\DRV8353Rx-1.0.1\drv8353Rx_instaspinFOC_FW\drv83xx_foc\instaspin_foc\boards\drv8353\f28x\f2802xF\projects\ccs\proj_lab05b) 

Using above mentioned directory, I have imported the code to ccs for compilation. based on the following user guidance image.

In the image highlighted step 1 to import the code and compile in CCS process, I got 37 error and the newly pop menu which mentioned in the above image is not appeared.

For error, please check the below attached image.

Hope for immediate reply. 

Thanks

Ramyaa R