LM61460-Q1: Which circuit should I take?

Kensuke Maezono1

Prodigy 95 points

Part Number: LM61460-Q1
Other Parts Discussed in Thread: LM61460

Hi, teams!

I show an example circuit of LM61460.

but there is a difference between datasheet(Rev.F) and webbench.

Which circuit should I take?

over 3 years ago

0 Xiaoying Lu over 3 years ago

TI__Expert 3470 points

Hi Kensuke,

Which difference are your referring to?

Generally speaking, datasheet only covers the typical application schematic, while for WEBench, you can input your requirements, like input voltage, output voltage, output current, temperature to get a specific schematic and see the simulation results.

Regards,

Xiaoying

0 Kensuke Maezono1 over 3 years ago in reply to Xiaoying Lu

Prodigy 95 points

Hi Xiaoying!

Thank you for your reply.

I understand that the constants of C, L, and R change, but I don't understand that the location also changes.
Can the position of Cout change?

0 Xiaoying Lu over 3 years ago in reply to Kensuke Maezono1

TI__Expert 3470 points

Hi Kensuke,

The place of Cout does not change. The figure you showed is the same as that in the datahseet.

As you can see, Cout always links between Output and GND.

Regards,

Xiaoying

Power management

Power management forum

LM61460-Q1: Which circuit should I take?