Hi team,
How is its nFAULT cleard (Hi-Z) from OCP event? DIAG_EN pin is high and Latch pin is floating.
Are the only way clear nFAULT "pull down EN" or "overcurrent condition is released"?
Regards,
Ochi
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi team,
How is its nFAULT cleard (Hi-Z) from OCP event? DIAG_EN pin is high and Latch pin is floating.
Are the only way clear nFAULT "pull down EN" or "overcurrent condition is released"?
Regards,
Ochi
Hi Ochi-san,
Yes you are correct that pull down "EN" which shuts off the part, or the overcurrent condition is released will be two ways to clear the fault. Also pull DIAG_EN low will release the FAULT as well.
Please let me know if you have additional questions.
Regards,
Yichi