TPS2544: 5V/2.4A protocol

Fred Cheng

Expert 5070 points

Part Number: TPS2544

Hi team,

my customer has new spec that support 5V/2.4A,

can we just change the iLIM_HI to 2.5A resistor ?

is there other thing we need to concern?

over 1 year ago

0 Aya Khedr over 1 year ago

TI__Genius 15982 points

Hi Fred,

Thank you for reaching out!

I'm going to check and will get back to you by Wednesday.

Best Regards,

Aya

0 Fred Cheng over 1 year ago in reply to Aya Khedr

TI__Expert 5070 points

alright , waiting for your feedback on wednsday

0 Aya Khedr over 1 year ago in reply to Fred Cheng

TI__Genius 15982 points

Hi Fred,

Is the customer wanting to source or sink here? If they are sourcing, there should not be an issue. If sinking, what is the operating current and the max current?

Best Regards,

Aya

0 Fred Cheng over 1 year ago in reply to Aya Khedr

TI__Expert 5070 points

source, just like regular sourcing but 5V/2.4A,

but I don't know TPS2544 can support sinking, you sure about that?

0 Aya Khedr over 1 year ago in reply to Fred Cheng

TI__Genius 15982 points

Hi Fred,

Yes, that should be fine for sourcing. I am not sure about sinking either. I would need to ask a team member. Please let me know if you have additional questions.

Best Regards,

Aya

0 Fred Cheng over 1 year ago in reply to Aya Khedr

TI__Expert 5070 points

Hi Aya,

it's alright,

just help me check internally about the sourcing , can I support 2.4A in CDP as well or only DCP?

0 Aya Khedr over 1 year ago in reply to Fred Cheng

TI__Genius 15982 points

Hi Fred,

Yes you can support 2.4A in both. Refer to the image below from the datasheet. The customer would need to follow the truth table to set the mode desired.

Best Regards,

Aya

Power management

Power management forum

TPS2544: 5V/2.4A protocol