Hi Team,
we'd like to choose below diode as boot diode. Not sure about leakage current since datasheet just mentioned it need to be low. Thanks.
VF=715mV@1mA,855mV@10mA
VBR=100V,IR 1uA。
VBR=70V,TJ=150℃,max:50uA
BRs
Given
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Team,
we'd like to choose below diode as boot diode. Not sure about leakage current since datasheet just mentioned it need to be low. Thanks.
VF=715mV@1mA,855mV@10mA
VBR=100V,IR 1uA。
VBR=70V,TJ=150℃,max:50uA
BRs
Given
Hello,
Thanks for reaching out. As stated in the datasheet at page 20, section 7.3.9: The leakage current of the boot diode should be always less than the BST charge pump sourcing current. From the EC table at page, the charge pump sourcing current is:
Please check the leakage current of the diode against this parameter. Let us know if further support is needed.
Kind regards,
EM