Hello,
My customer has a design where the top resistor of ADRSEL_A is 1.1kOhm and the bottom is 10kOhm. Based on the datasheet, this seems like it corresponds to address 0x24h (36d). But the device responds to 0x14h (20d) instead. Are we misinterpreting the datasheet?
Thanks,
Michael
Hi Michael,
The address should be 20d with top resistor DNP and bottom resistor 10k. Please see below from design tool. How do you think it should be 24d?
Thanks,
Nancy
Hi Nancy,
My question is about 1.1k top resistor and 10k bottom resistor. What address should that be?
The device on the customer board is responding to 20d with these resistors. We are expecting it to respond to 36d.
Thanks,
Michael
