UCC25600: PSpice simulation error

Navaneethraj MV

Prodigy 10 points

Part Number: UCC25600

Hi,

I am unable to save UCC25600 simulations in Pspice for TI tool. It's giving the below error message.

10 months ago

0 David Larkin 10 months ago

TI__Genius 16060 points

Hi Navaneethrj,

I did a search on ORCAP-1682 and the only hit I got was from 2011. An issue with the name being in lower case, but that was supposedly fixed.

I was able to pull the reference design for this part and run the transient without a problem.

Can you confirm your version? Go to Help, About and you should see PSpice for TI, PSpice_TI, 17.4-2023 S009

Did you first run the reference design? If that works, it might give us a clue as to what's going on.

David

0 Navaneethraj MV 9 months ago in reply to David Larkin

Prodigy 10 points

Hello David,

My version is 17.4-2023 S009 SPB 64 bit Edition.

Yes, i can run the reference design and it is working.

0 David Larkin 9 months ago in reply to Navaneethraj MV

TI__Genius 16060 points

The ORCAP-1151 error can be resolved as follows:

This is because the active simulation profile is not configured to the schematic you are trying to simulate. Please right click on the correct simulation profile and make it active.

David

0 Navaneethraj MV 9 months ago in reply to David Larkin

Prodigy 10 points

Hello David,

Thanks for the support, the issue is resolved.

Thanks

Navaneeth

Power management

Power management forum

UCC25600: PSpice simulation error