LMQ66410: Selection recommendation

Anna

Part Number: LMQ66410

HI Dear,

The customer needs to obtain intrinsic safety certification for underground related equipment. The certification requires that the total capacitance in the circuit cannot exceed a certain value. May I ask if there is a bypass capacitor that can achieve a DC-DC chip of 1uF, with an input voltage of around 22V and an output requirement of around 1-2A

10 months ago

0 Ridge Lahti 10 months ago

TI__Genius 13495 points

Hello,

Please refer to Section 9.2 of the datasheet for typical external component recommendations for common operating conditions of the LMQ66410: https://www.ti.com/lit/ds/symlink/lmq66410.pdf

Best regards,

Ridge

0 Anna 10 months ago in reply to Ridge Lahti

Intellectual 930 points

Hi Ridge,

Do you have any other recommended models that can achieve a bypass capacitor of 1uF?

0 Ridge Lahti 10 months ago in reply to Anna

TI__Genius 13495 points

Hello Anna,

The capacitance requirements often depend on the current requirements in the application and also the input supply characteristics (eg. regulator or not?)

Normally the datasheet includes a value that has been tested and validated across corner cases to show that the IC will operate properly. In practice, this capacitance may not be required for every single application. In some applications, additional capacitance could be required. One could evaluate the performance of the part with lower input capacitance. For example, here is an application note that could help you determine the minimum input capacitance for a typical buck application: https://www.ti.com/lit/an/slyt670/slyt670.pdf

I would suggest using the Webench tool to select an IC for your application and optimize your input capacitance: https://www.ti.com/tool/WEBENCH-CIRCUIT-DESIGNER

Best regards,

Ridge

Power management

Power management forum

LMQ66410: Selection recommendation