UCD90160: introduction of UCD90160

Comi Li

Intellectual 2920 points

Part Number: UCD90160
Other Parts Discussed in Thread: UCD9090

Hi team,

Our customer uses UCD90160. Can we give a basic introduction of UCD90160? They don't know how to use it.

By the way, what's the difference between 90160 and 9090?

Thanks for your support.

Regards，

Comi

10 months ago

0 yihe 10 months ago

TI__Guru 60800 points

There are many documents and training video.

Training videos are here:

https://www.ti.com/sitesearch/en-us/docs/universalsearch.tsp?langPref=en-US&preFilter=video&searchTerm=fusion%20digital%20power%20designer&nr=40#q=fusion%20digital%20power%20designer&sort=relevancy&numberOfResults=25&f:videos=[Video,Video%20series]

user guide

https://www.ti.com/lit/pdf/slvub51

You can also refer the below quick guide.

0844.UCD90xxx 简易使用手冊.pptx

Regards

Yihe

0 Comi Li 10 months ago in reply to yihe

TI__Intellectual 2920 points

Hi Yihe，

Thanks for your information about UCD90160 !

I check the datasheet of UCD90160 and UCD9090.

The UCD9090 monitors up to 10 voltage rails and the UCD90160 monitors up to 16 voltage rails, not much difference otherwise, right?

Regards,

Comi

0 Travis Williams 10 months ago in reply to Comi Li

TI__Expert 8960 points

Hi Comi,

We're looking into this. Expect more info tomorrow.

Thanks,

Travis

0 yihe 10 months ago in reply to Comi Li

TI__Guru 60800 points

Please choose the sequencer based on your system requirements such as how many channels

the main features are very similar

If you have special requirements please let me know

regards

yihe

0 Comi Li 10 months ago in reply to yihe

TI__Intellectual 2920 points

Hi Yihe,

Customers want to know how to read the status information of the monitored voltage?

What are the ways to read the monitored information? (If GUI is not used)

How to configure the function of GPIO?

Regards，

Comi

0 yihe 10 months ago in reply to Comi Li

TI__Guru 60800 points

Please follow section 4 of https://www.ti.com/lit/pdf/slva385 to read.

We recommend using GUI to do the configuration.

Please refer the commands here

https://www.ti.com/lit/pdf/slvu352

Regards

Yihe

Power management

Power management forum

UCD90160: introduction of UCD90160