LM5118: LM5118

Hi,

1. Vin(min) - 9V
2. Vin(max) - 69V
3. Vout - 12V
4. Iout - 3A

For the Enable signal, we are planning to use a GPIO from controller to toggle the pin. In datasheet it has been mentioned that, Enable pin status as per the voltage across the pin

<0.7V - Enable is LOW , IC is off

>3V  - Enable is High - IC in Normal operation.

So, can we directly connect a GPIO of 3.3V on EN pin to control the IC. Or do we still need to use BJT or MOSFET to have a level shifting?

Regards,

Hareesh