Other Parts Discussed in Thread: TLC59108
Hi,
I am trying to use the TLC59108F device. The device reply to me well and I don't understand why it doesn't works.
In particolar, I configure the device by set normal mode into MODE1 register.
After that, I put all the LEDs in OFF mode by using LEDOUT0 and LEDOUT1.
After that, every 500ms I swit1253ch the LED1, LED2 and LED3 to full ON and then OFF.
If I put a LED in PWM mode, it works only if I put 0 or 255 into the register, otherwise it remains always on.
Where is the error?!?
Thanks
Marco