• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 63 subscribers
  • Views 50 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

TPS628503-Q1: Questions on Fsw and Switching Node Waveform

TPS628502-Q1: SW node overshoot

Momchil Haymanov
Prodigy 40 points
Part Number: TPS628502-Q1

Hello there, 

I am measuring a huge overshoot on the SW node of the TPS628502-Q1.

Vin 4.2V, Vout 3.3V, Iout=0A, FPWM mode.

Trise 0.7us, Vpeak=6.46V. Is this normal behavior for the device? 2.2V overshoot is huge. 

This measurement is taken on the EvKIT with 4GHz scope, 500Mhz probe with sping.

 

Regards, 

Momchil Haymanov

  • +1
    TI__Genius 14415 points

    Hello Momchil,

    thanks for reaching out in E2E.

    It might be possible to optimize the measurement a bit by reducing the GND spring length of the probe and by connecting GND directly at the IC pin.

    Nevertheless, this very short time overshoot is also normal behavior and no quality or reliability concern, as it is in compliance to the datasheet maximum ratings.

    Best regards,

    Andreas.