TUSB1046A-DCI: TUSB1046A-DCI

he henry

Part Number: TUSB1046A-DCI
Other Parts Discussed in Thread: TDP142

Tool/software:

Hi， TI

I have a question about TUSB1046. the question is that our CPU output signal is eDP, can it be connect to TUSB1046 directly? and then connect from TUSB1046 to Type-c connector as DP signal?

3 months ago

0 David (ASIC) Liu 3 months ago

TI__Guru**** 152496 points

Hi,

Yes, you can connect the eDP signal directly to the TUSB1046A-DCI and then output to the Type-C connector.

Thanks

David

0 he henry 2 months ago in reply to David (ASIC) Liu

Prodigy 10 points

THANKS David，

if we want use the full function of the Type-C，does TI have the REF design and if the chip need special FW，can you give support

0 David (ASIC) Liu 2 months ago in reply to he henry

TI__Guru**** 152496 points

Hi,

You can use the EVM as the reference schematic, please see this link https://www.ti.com/tool/TUSB1046EVM for the EVM schematic.

TUSB1046A-PCI can be configured in pin-strap or I2C mode, there is no special FW needed.

Thanks

David

0 he henry 2 months ago in reply to David (ASIC) Liu

Prodigy 10 points

Thanks David

0 he henry 2 months ago in reply to David (ASIC) Liu

Prodigy 10 points

Hi， David

if i just use it as a eDP-DP bridge,how to candle the unused pins? like cc sbu cad_snk etc

0 David (ASIC) Liu 2 months ago in reply to he henry

TI__Guru**** 152496 points

Hi,

So you will not use the Type-C connector for this design? If this is the case, please consider using TDP142, and you can use TDP142 EVM as the reference design.

HSDC029A_Schematic.pdf

Thanks

David

0 he henry 2 months ago in reply to David (ASIC) Liu

Prodigy 10 points

No,I still want to use the Type-C connector, Please help to consider how to handle it.

0 David (ASIC) Liu 2 months ago in reply to he henry

TI__Guru**** 152496 points

Hi,

You would need to use a PD controller to support DP Alt Mode over Type-C, and you can use the TUSB1046A EVM as a reference on how to connect the CC, SBU, and CAD_SNK.

Thanks

David

0 he henry 2 months ago in reply to David (ASIC) Liu

Prodigy 10 points

You mean that I must use a PD controller with the TUSB1046 device even if I don't want the PD and USB3 function?

0 David (ASIC) Liu 2 months ago in reply to he henry

TI__Guru**** 152496 points

Hi,

Correct, you have to use a PD controller to support the DP Alt Mode over Type-C.

Thanks

David

Power management

Power management forum

TUSB1046A-DCI: TUSB1046A-DCI