UCC28742: AC - DC Power Supply part selection

Basit Ali Khan

Part Number: UCC28742 UCC256402
Other Parts Discussed in Thread: UCC28950, UCC28251, UCC2894, UCC256402, UCC25640EVM-020, UCC25640

Tool/software:

Hi,

I am designing a Power supply having following parameters:

Input Voltage: 85VAC - 265VAC
Input Frequency: 50Hz - 60Hz
Output Voltage: 12V DC
Output Current: 25A
Protection: input under-voltage protection, input over-voltage protection, input surge protection, output over-voltage protection, output over-current protection

Need to find a suitable part for it.

13 days ago

0 Hong Huang 13 days ago

TI__Guru 50795 points

Hi,

The Pout = 300W. I suggest you use UCC28950 phase shifted full bridge. Flyback does not seem a good candidate for such a high power.

0 Basit Ali Khan 12 days ago in reply to Hong Huang

Prodigy 160 points

Thanks. Any other part number if I reduce Pout = 200W i.e. 12V 16A.

+1 Hong Huang 12 days ago in reply to Basit Ali Khan

TI__Guru 50795 points

Hi,

200W still too large for flyback. UCC28950 can still be used or UCC28251 for half bridge.

Flyback usually is to be used 120W or less.

Forward is roughly ok for 200W then UCC2894 can be considered if you do not want use half bridge or full bridge.

I see UCC256402 for LLC which is ok to use for 200W but it is better to have narrow input which is not your case.

0 Basit Ali Khan 11 days ago in reply to Hong Huang

Prodigy 160 points

In the UCC25640EVM-020 evaluation board schematics I dont see any link between the VIN (2? marked) and the AC input point (1? marked) so are they both connected or this is something else and both AC and DC inputs are separately applied.

0 Hong Huang 11 days ago in reply to Basit Ali Khan

TI__Guru 50795 points

Hi ,

AC DC needs a rectifier circuit. Please open a new thread with UCC25640 to get better support and get your questions answered by the dedicated experts on that device.

Power management

Power management forum

UCC28742: AC - DC Power Supply part selection