This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software:
Dear Texas Instruments Team,
I am currently working with the TPSF12C1 model in PSpice and have encountered an issue:
When I set the VAMPL parameter to 5V and VOFF of the supply voltage to 0V in the simulation circuit, I do not see any changes in the diagram after clicking "Run PSpice".
This also occurs when I try to connect multiple AC voltage sources in parallel to simulate disturbances.
Could you please advise if there are specific configurations or limitations that I need to consider to simulate these changes correctly?
Thank you in advance for your support!
Best regards,
Tim Evers
Hello Tim,
Could you please confirm if you were using the exact PSpice model that you downloaded from the product page of TPSF12C1 (TPSF12C1 data sheet, product information and support | TI.com)?
If not, could you please download our PSpice model from the page and copy the exact simulation settings to run the simulation?
If the problem still persists after copying the exact simulation settings from our page, it could be because of the circuit you are using and not the simulation settings.
I am directing this to an expert on PSPICE for providing additional feedback.