LM76003: Ven rising and falling hysteresis

Sadanori Kato

Part Number: LM76003

Hi,

Does Venh in the following formula mean "Ven_vout_h" for the rising threshold ?
Also, does Venl mean "Ven_vout_h - Ven_vout_hys" for the falling threshold ?
In addition, could you please share the minimum and maximum value for Venh and Venl ?

Best regards,
Kato

over 5 years ago

0 Katelyn Wiggenhorn over 5 years ago

TI__Genius 11040 points

Hello,

You are correct. The VENH is referring to the enable voltage at which the device is ready to start switching. This is VEN_VOUT_H in the EC table. The VENL is referring to the VEN_VOU_H - VEN_VOUT_HYST in the EC table.

This specification is not on the datasheet and cannot be shared on the public forum. Please e-mail me directly to discuss further (k-wiggenhorn@ti.com).

Thank you,
Katelyn

0 Sadanori Kato over 5 years ago in reply to Katelyn Wiggenhorn

Guru 36500 points

Hi Katelyn-san,

Thank you for the information.

I understood and will contact you via an email if our customer needs more information.

Best regards,
Kato

0 Katelyn Wiggenhorn over 5 years ago in reply to Sadanori Kato

TI__Genius 11040 points

Hello,

Thank you. I am going to close this thread, and we can continue the discussion over e-mail if necessary.

Thanks,
Katelyn

0 Sadanori Kato over 5 years ago in reply to Katelyn Wiggenhorn

Guru 36500 points

Hi Katelyn-san,

Thank you for your cooperation.

Best regards,
Kato

Power management

Power management forum

LM76003: Ven rising and falling hysteresis