WEBENCH-POWER-DESIGNER: Confirmation: LM5155-Q1 design

May

Part Number: WEBENCH-POWER-DESIGNER
Other Parts Discussed in Thread: PMP40569

Hi Team,

Good day.

Customer want to confirm if the CS pin was not design to connect in the Rcs and Ccs. Kindly refer to attached image below.

Thank you and looking forward for your kind response.

Regards,

Maynard

over 4 years ago

0 Victor Yu over 4 years ago

TI__Expert 4841 points

Hi Maynard，

Although I‘m not familiar in this field, I'd like to discuss with you about this question.I think Rcs and Ccs is needed here. Your customer may refer to PMP40555 and PMP40569 for a flyback solution.

Thanks.

BR,

Victor

0 Ulf Lehmann over 4 years ago in reply to Victor Yu

Prodigy 165 points

I don't ask whether I can remove Ccs and Rcs, but rather whether a connection between pin CS and Ccs / Rcs is missing?

0 Victor Yu over 4 years ago in reply to Ulf Lehmann

TI__Expert 4841 points

Hi Ulf，

The connection is needed here. If not, these Res and Cap will be meaningless.

BR,

Victor

0 Ulf Lehmann over 4 years ago in reply to Victor Yu

Prodigy 165 points

Ok, as expected

Thx

0 Victor Yu over 4 years ago in reply to Ulf Lehmann

TI__Expert 4841 points

Hi Ulf，

I'll close this thread. If you have any new questions, E2E forum is always here. Thanks.

BR,

Victor

Power management

Power management forum

WEBENCH-POWER-DESIGNER: Confirmation: LM5155-Q1 design