TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] TLC6C5748-Q1: How to use TLC6C5748-Q1 to build a local dimming system?

    Caryss Li
    Caryss Li
    Part Number: TLC6C5748-Q1 Hi How to use TLC6C5748-Q1 to build a local dimming system? How to design the hardware? how to design the LED board? How to connect LED drivers with TCON? what is the TCON partnumber? How to do the layout?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] LM5176: just work as buck controller

    Jiawei Hu1
    Jiawei Hu1
    Part Number: LM5176 Other Parts Discussed in Thread: LM5146 , , LM5175 Hi team, Since of LM5146 out of stock, I have several questions about LM5176: Can LM5176 work as buck controllers? Just use two Mos? Is LM5176 have any EMC improvement compared…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] LM2611: how to generate -2.5V

    Omid Barkhordarian
    Omid Barkhordarian
    Part Number: LM2611 I want to know how to generate -2.5V with this part. I read the datasheet and I don't see any reference in how to configure the part. 8.2.3.1 Design Requirements This design converts 9 V (VIN) to –5 V (VOUT). Adjust RFB2 to set a…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS92200: [FAQ] TPS92200: How to master TPS92200D1/D2 device in indusrials markets within five minutes?

    Sean Zhou
    Sean Zhou
    Part Number: TPS92200 Hi TI Experts, I have found that TPS92200 is a very cost optimized device with good performance. And I want to use this in my new projects. Could you give me a quick introduction and design guideline for this device? Thanks.
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TLC6983EVM: [FAQ] TLC698x: How to master TLC698x devices in LED Wall market within five minutes?

    Sean Zhou
    Sean Zhou
    Part Number: TLC6983EVM Other Parts Discussed in Thread: TLC6983 , , MSP430F5529 The TLC6983 is a highly integrated common cathode matrix LED display driver with 48 constant current sources and 16 scanning FETs. A single TLC6983 is capable of driving…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] LM5176-Q1: Automotive and non-automotive part compatibility

    jars121
    jars121
    Part Number: LM5176-Q1 Other Parts Discussed in Thread: LM5176 , Hi, I'd just like to confirm that the automotive variants of the LM5176 are 100% compatible as a drop-in replacement for the non-automotive variants? I.e. my design uses an LM5176PWPR…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS53318: [Grounding the ROVP Pin on TPS53318 & TPS53319

    David_Daniels
    David_Daniels
    Part Number: TPS53318 What is the recommended connection for the ROVP pin?
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS546D24A: Does the USB-to-GPIO dongle have internal pull-ups? What resistance? To what voltage?

    Peter James Miller
    Peter James Miller
    Part Number: TPS546D24A The TI USB-to-GPIO interface dongle does include internal pull-ups to the on-board 3.3V supply voltage. The Pull-up resistor values are selectable with 4 levels, set through the USB Adapter Settings option under the TOOLS menu…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS546D24A: What termination voltage can the PMBus / SMBus / I2C bus pins support and what pull-up resistors should be used?

    Peter James Miller
    Peter James Miller
    Part Number: TPS546D24A Can the TPS546D24A PMBus / SMBus / I2C port be pulled up to 1.8V? The TPS546D24A's digital interface pins PMB_CLK and PMB_DAT are designed to support SMBus 3.1 1MHz class High-Power digital interface. Per the SMBus 3.1 specification…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] UCC21520: Parallel resitor between Gate and Source and 0V ground plane

    Pablo Acuna
    Pablo Acuna
    Part Number: UCC21520 Hi, I have seen a 10kOhm resistor between Gate and Source (see R14 and R12 in the attached fig from tidue55b.pdf), but I cant figure out why the resistor is there. My guess is because measuring purposes without a MOSFET being…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    BQ76952: Will BQ76932 shut down if it is not pwered to VC16? 0 Locked

    309 views
    4 replies
    Latest over 1 year ago
    by Sho Takayama
  • Suggested Answer

    TPS6521905-Q1: Enable/Disable the individual power output 0 Locked

    235 views
    2 replies
    Latest over 1 year ago
    by Brenda Diaz
  • Suggested Answer

    BQ79600-Q1: where can I get the SPI/UART Sample code file? 0 Locked

    247 views
    1 reply
    Latest over 1 year ago
    by Abigail Bueno
  • Suggested Answer

    Processors forum 0 Locked

    603 views
    18 replies
    Latest over 1 year ago
    by Sarabesh Srinivasan
  • Suggested Answer

    BQ79731Q1EVM-060: Power management forum 0 Locked

    497 views
    8 replies
    Latest over 1 year ago
    by Michelle Williams
  • Answered

    TL7700-SEP: TL7700-SEP Filtered Sense 0 Locked

    350 views
    3 replies
    Latest over 1 year ago
    by Andy Fondaw
  • Suggested Answer

    TPS28225-Q1: PCN : 20231220001.2 0 Locked

    779 views
    17 replies
    Latest over 1 year ago
    by William Moore
  • Suggested Answer

    BQ79731Q1EVM-060: & BQ79731Q1EVM-060 user guide and GUI tool 0 Locked

    422 views
    1 reply
    Latest over 1 year ago
    by Nancy Hidalgo
  • Suggested Answer

    BQ24259: IC getting exceptionally hot, and not charging Li-Po battery 0 Locked

    460 views
    2 replies
    Latest over 1 year ago
    by Garrett Kreger
  • Suggested Answer

    BQ76PL455EVM-GUI-SW: Unable to open COM port 0 Locked

    500 views
    3 replies
    Latest over 1 year ago
    by David Ray
  • Not Answered

    LM61495: Regarding PMIC Combination of TPS62067, TPS568215, TPS65023 for Xilinx Artix-7 FPGA XC7A200T-2FBG676I 0 Locked

    350 views
    1 reply
    Latest over 1 year ago
    by Jimmy Hua
  • Answered

    UCC21520: Relay to connect and disconnect transformers at the switch node of SMPS 0 Locked

    255 views
    2 replies
    Latest over 1 year ago
    by Bright Robert
  • Not Answered

    BQ27426: BQ27426 0 Locked

    439 views
    12 replies
    Latest over 1 year ago
    by Anthony
  • Not Answered

    BQ40Z80: BQ40Z80RSMT 0 Locked

    269 views
    4 replies
    Latest over 1 year ago
    by Anthony
  • Answered

    TPS25730: How to operate with separate PD Protection 0 Locked

    557 views
    4 replies
    Latest over 1 year ago
    by Joe Paolino
  • Not Answered

    BQ34110: BQ34110 Burning and Writing DATA Flash 0 Locked

    297 views
    3 replies
    Latest over 1 year ago
    by Diego
  • Suggested Answer

    BQ34Z100-G1: SOC calculation error 0 Locked

    575 views
    15 replies
    Latest over 1 year ago
    by Diego
  • Suggested Answer

    BQ34Z100-R2: LED button suddenly stopped working 0 Locked

    504 views
    11 replies
    Latest over 1 year ago
    by Diego
  • Answered

    LMR43610-Q1: Missing SPICE Model for Simulation 0 Locked

    395 views
    1 reply
    Latest over 1 year ago
    by Jimmy Hua
  • Suggested Answer

    TPS7H1101A-SP: Grounding Unused Pins 0 Locked

    333 views
    3 replies
    Latest over 1 year ago
    by Sarah Koch
<>