TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] What is the function of the MPPSET voltage on the BQ24650?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24650 The function of the BQ24650 MPPSET pin is to hold the input voltage (known as the Maximum Power Point Voltage) at a set point in the event that the input power drops. It is set as a voltage divider from the input to the MPPSET…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] Can the EV2400 be used to communicate with the BQ25792 through BQSTUDIO on the board USB-PD-CHG-EVM-01?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: USB-PD-CHG-EVM-01 Other Parts Discussed in Thread: BQSTUDIO , BQ25792 , EV2400 Yes, the EV2400 and BQStudio can be used to communicate with the charger BQ25792. Please connect the EV2400 to the J7 header with the GND wire closest to…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How do I configure the TPS25750 and flash the EEPROM with the output binary for the board USB-PD-CHG-EVM-01?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: USB-PD-CHG-EVM-01 Other Parts Discussed in Thread: TPS25750 , Open the TPS25750 Application Customization Tool and … Select all of the desired PD controller and charger parameters. Select “Download Full Flash Binary.” Power the USB…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How is the input current limit determined for the BQ25882, BQ25883, BQ25886, and BQ25887 chargers?

    Angelo Zhang87
    Angelo Zhang87
    Other Parts Discussed in Thread: BQ25886 How do I set the input current limit for these chargers?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How should the /BATPRES pin be connected on the following chargers: BQ24770, BQ24773, BQ24780S?

    Angelo Zhang87
    Angelo Zhang87
    Other Parts Discussed in Thread: BQ24780S What is the function of the charger's /BATPRES pin, and how should this pin be connected?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] Do the following chargers have a termination current setting: BQ24715, BQ24725A, BQ24735, BQ24770, BQ24773, BQ24780S?

    Angelo Zhang87
    Angelo Zhang87
    Do these chargers have a termination current setting at which point the device terminates the charge cycle, or will the charge current taper all the way down to zero in CV (constant voltage) mode?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] Can the following chargers be used to charge smart batteries: BQ24715, BQ24725A, BQ24735, BQ24770, BQ24773, BQ24780S?

    Angelo Zhang87
    Angelo Zhang87
    Can these chargers be used to charge smart batteries? Are they SBS 1.1 compliant?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62901: How do you select the MODE/S-CONF pin resistor?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62901 What is the accepted resistor tolerance for the MODE/S-CONF pin resistor on the TPS6290x device? Can I use a value greater than 118k Ohm?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why VSYS does not start up normally when there is a loading on the SYS and the battery is not present for BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ25898C, BQ24190, BQ24192, BQ24192I, BQ24195, BQ24292I...

    Ning T
    Ning T
    Part Number: BQ25890 Other Parts Discussed in Thread: BQ24190 , BQ25898 , BQ24296 , BQ24192I , BQ25895 , BQ25896 , BQ24193 , BQ24192 , BQ24292I , , BQ24295 , BQ24298 , BQ25898C , BQ25898D , , BQ24259 , BQ25895M , BQ25892 , BQ24296M , BQ24195 , BQ24196…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS548A20: Bode Plot Measurements

    Kadeem Samuel
    Kadeem Samuel
    Part Number: TPS548A20 Do Bode plots for the TPS548A20 exist? If so, where can I find them?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    BQ76PL455A: we met some prolems when connect three BQ76PL455A 0 Locked

    497 views
    1 reply
    Latest over 7 years ago
    by David Wiest Jr
  • Answered

    UCD9090A: Initialization routine time after reset 0 Locked

    530 views
    1 reply
    Latest over 7 years ago
    by yihe
  • Suggested Answer

    BQ24166: USB adapter and AC adapter 0 Locked

    651 views
    1 reply
    Latest over 7 years ago
    by Jeff F
  • Suggested Answer

    Limit current for Li-Ion battery charging 0 Locked

    568 views
    1 reply
    Latest over 7 years ago
    by Wang5577
  • Suggested Answer

    TPS54386: 24V to 5V and 3.3V possible with TPS54386? 0 Locked

    2270 views
    7 replies
    Latest over 7 years ago
    by JohnTucker
  • Answered

    LMZM33603: Release Date 0 Locked

    460 views
    1 reply
    Latest over 7 years ago
    by J Arrigo
  • Suggested Answer

    BQ76PL455A-Q1: Bq 76 pl 455a-q1 0 Locked

    820 views
    1 reply
    Latest over 7 years ago
    by David Wiest Jr
  • Suggested Answer

    BQ76PL455EVM: UART communication 0 Locked

    1331 views
    5 replies
    Latest over 7 years ago
    by David Wiest Jr
  • Answered

    BQ24170: Why BQ24170 had a initial charge cycle detect? 0 Locked

    288 views
    1 reply
    Latest over 7 years ago
    by Steven Bangdiwala
  • Suggested Answer

    TPS5430: TPS5430 load derating curve 0 Locked

    318 views
    1 reply
    Latest over 7 years ago
    by JohnTucker
  • Answered

    UCC28180: Bidirectional power flow along with Unity power factor 0 Locked

    1031 views
    4 replies
    Latest over 7 years ago
    by Shivkant Sharma12
  • Answered

    TLC6C5712-Q1: PWM Dimming Duty 0 Locked

    454 views
    1 reply
    Latest over 7 years ago
    by Anda Zhang
  • Answered

    LMR14020: VIN=EN condition 0 Locked

    355 views
    1 reply
    Latest over 7 years ago
    by Jason Wang (BSR-MV)
  • Suggested Answer

    UCC28951-Q1: Difference with UCC28950 0 Locked

    734 views
    1 reply
    Latest over 7 years ago
    by Colin Gillmor
  • Answered

    CCS/BQ20Z45: where to obtain respective driver and software for Evaluation module testing 0 Locked

    784 views
    2 replies
    Latest over 7 years ago
    by Lakshimi Palaniswamy
  • Suggested Answer

    uc2526: not getting PWM output from UC2526 IC 0 Locked

    5181 views
    13 replies
    Latest over 7 years ago
    by Sonal Singh
  • Answered

    BQ34Z100-G1: Programming a new Chemical ID into the BQ34Z100-G1 from an external file 0 Locked

    5395 views
    19 replies
    Latest over 7 years ago
    by Alan Ogburn73
  • Not Answered

    UCC28061: UCC29061 Rogue Gate Drive Pulse Unit runs in Phase and Jumps out to Sync mode and then back to Phase mode ? 0 Locked

    2061 views
    3 replies
    Latest over 7 years ago
    by John Griffin1
  • Suggested Answer

    UCC28711: Tida-00173 tecnical help 0 Locked

    993 views
    2 replies
    Latest over 7 years ago
    by Bernard Keogh
  • Suggested Answer

    TLC5954: TLC5954 LED Sink Current Question 0 Locked

    447 views
    1 reply
    Latest over 7 years ago
    by Kenneth Du
<>