• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 64 subscribers
  • Views 330 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Schematic and Layout Tools

Valerio Abate
Prodigy 60 points
Other Parts Discussed in Thread: PMP4480, UCC28710

Hi,

can I know which tool I have to use to read .sch and .pcb files released with PMP4480 Ref.Design.

Regards,

Valerio

  • 0
    TI__Mastermind 31580 points
    Hi

    The is a link to a viewer on the web page, other than that the files are either PADs or Altium.

    Regards

    Peter
  • 0 in reply to Peter Meaney
    Prodigy 20 points
    Thanks,

    I checked design and I verify that the Transformer I ordered according to suggested BOM is for 5V@1A instead of 12V@1A I expected. Could I set the board using this transformer for 12V@1A not allowing 85VAC as per minimum line voltage but accepting 150-180VAC as per ucc simulation ?

    It will help me not to waste time in remaking the completelly the prototypes. TI ucc28710 tool allow 14:1 and 6,59:1 ratios if minimum voltage level is increased; it is viable ?

    Regards

    Valerio