This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS55288: TPS55288 FB/INT PIN Problem

Intellectual 285 points

Replies: 4

Views: 59

Part Number: TPS55288

Dear TI support 

     Can you help check , Why I use TPS55288  PIN14( FB/INT)  the function not implemented?

    

     I use internal feedback, and external pull-up resistors, According to the function, it should be pulled down if there is a problem, but now OK work is also pulled down, please help to confirm, or point out how I need to use the abnormal function of FB/INT, I need to use this PIN to judge the working status。

    

    Thanks !

    

4 Replies

  • Dear Sir,

    Could you please share the schematic with us, does the INT pin pulled high? Please refer to the TPS55288EVM board, there's a 100k ohm resistor pull high to a 5V VCC.

    Best Regards,
    Helen

    Boost DC/DC Solution

  • In reply to Helen chen:

    Dear helen:

    The circuit diagram is as follows, we have a pull-up resistor, and the software is set to internal FB function.

  • In reply to user4720651:

  • In reply to user4720651:

    Dear Sir,

    I checked on the EVM board, the INT function is good.

    Please check the setting in your I2C, is it well set? Please compare with below picture.

    Best Regards,
    Helen

    Boost DC/DC Solution

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.