[FAQ] 66AK2E05: How to run the GPIO-LED example on the K2E EVM ( ARM core ) -or- K2H EVM (ARM core ) ?

How to run the GPIO-LED example on the K2E EVM ( ARM core )  -or- K2H EVM (ARM core ) ?

Pre-requisite:         

1. Install Processor SDK 6.3
   1. For K2E: processor_sdk_rtos_k2e_6_03_00_106 from http://software-dl.ti.com/processor-sdk-rtos/esd/K2E/latest/index_FDS.html  -OR-              For K2H :PROCESSOR-SDK-RTOS-K2HK  06_03_00_106 https://software-dl.ti.com/processor-sdk-rtos/esd/K2HK/latest/index_FDS.html
2. Install CCS 9.3 from CCSTUDIO_9.3.0.00012 | TI.com
3. Choose the installation directory as C:\ti

Step1:

Generate the PDK examples by following this link:-

For K2E 

https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1040858/faq-66ak2e05-how-to-generate-the-ccs-pdk-examples-for-k2e/3849002#3849002

For K2H

[FAQ] 66AK2H14: How to generate the CCS PDK examples for 66AK2H14 - k2H EVM? - Processors forum - Processors - TI E2E support forums

Step2:

For K2E :  DIP switch settings of the K2E EVM in "NO BOOT" -- SW1 - 1,2,3,4 -- OFF, OFF, OFF, OFF.

For K2H : DIP switch settings of "NO BOOT" -- SW1 - 1,2,3,4 -- OFF, OFF, OFF, ON.

Step3:

Watch the video, below and follow the steps.

The steps in the video are captured for K2E EVM. However, the same procedure shall be applied for K2H EVM too.

Regards

Shankari G