TDA2EXEVM: Boot from emmc's boot partition

yancc

Part Number: TDA2EXEVM

Hi,ti expert

I checked the trm of tda2e17, which supports booting from the boot part of emmc,in the image below:

In linux, I wrote MLO and u-boot-spl.bin to the boot1 partition of emmc respectively through the dd command,

Then, modify the startup configuration of the board as shown in the figure above, and then power it up again.

Serial port doesn't respond.

Can you tell me how to program MLO to the boot partition of emmc?

0 Keerthy J over 2 years ago

"Using eMMC Boot" Section.

Best Regards,
Keerthy

0 yancc over 2 years ago in reply to Keerthy J

Hi,keerthy

Thank you very much for your reply.I have another question, no one has answered me, please help me

thanks!

0 wang liu over 2 years ago

Hello,

have you solved this problem? I have the same problem. Please give me some help.

Thank you

0 yancc over 2 years ago in reply to wang liu

Hi,

I haven't solved this yet.

0 yancc over 2 years ago in reply to yancc

Hi,keerthy

The pdf file content of the link above, not the solution I want.

I want to program MLO to the boot1 or boot2 partition of emmc, which is the data partition of rawdata,

not the boot partition of the vfat file system created by myself

Processors forum