difference between TMS320DM6467ZUTA and TMS320DM6467CCUTA ?

Hi Senthil,

Looking at your answer the CUT and ZUT package are mechanically equivalent. Correct?
Q: So are the differences in term of material declaration or lead/ball finish?

The "Quality & environmental data" section of the web does not anymore list the ZUT package so it makes it difficult to compare with CUT package:
www.ti.com/.../quality
www.ti.com/.../quality
Q: Could you please make the equivalent data available for DM6467ZUT/DM6467TZUT (see picture below)?
It is important to understand if the device handling or soldering process need to be adapted for CUT vs ZUT.

Thanks in advance.

A.

Hello AnBer,

Looking at your answer the CUT and ZUT package are mechanically equivalent. Correct?
Q: So are the differences in term of material declaration or lead/ball finish?

Yes, both package are having same mechanical specifications. But i am not sure about lead/ball finish, will check with the packaging team and update you.

The "Quality & environmental data" section of the web does not anymore list the ZUT package so it makes it difficult to compare with CUT package:
www.ti.com/.../quality
www.ti.com/.../quality
Q: Could you please make the equivalent data available for DM6467ZUT/DM6467TZUT (see picture below)?
It is important to understand if the device handling or soldering process need to be adapted for CUT vs ZUT.

The ZUT package devices are on lifebuy status, that could be a reason for non-availability of quality data. Please refer your earlier thread below. I think the similar data could be applicable for DM6467 too.

https://e2e.ti.com/support/dsp/davinci_digital_media_processors/f/99/p/249425/874056

Regards,

Senthil