TMS320C5515: Issue using XDS110 Debug Probe on CCS v9.3.0

Jack Bysouth

Part Number: TMS320C5515

Hi,

We have been using the single point DSP on one of our boards for some time now and I am currently designing a new test box for the board. Previously we have been using the XDS100v2 programmer with CCS v4 without any issues but when i try to programme the chip using the XDS110 programmer via CCSv9.3.0, on some board i get a memory read block error.

Would you be able to advice why i might be seeing this on the new programmer but not the old one? When I see the error whilst using the new programmer (XDS110) , I can switch to the old programmer (XDS100v2) and programme it without any issues. Once programmed i can then go back to the new one (XDS110) and get the error again.

Regards,

Jack Bysouth

over 3 years ago

0 Ki over 3 years ago

TI__Guru**** 421650 points

Hi Jack,

If you run the JTAG connectivity test, what are the full results?

Thanks

0 Jack Bysouth over 3 years ago in reply to Ki

Prodigy 20 points

Hi Ki,

Yes, i did carry otu the JTAG connectivity tests and they came back fine. I can't remember what the report stated but i can re-run it and post the report if there is any info in it that could help point to the issue am seeing.

Jack

0 Ki over 3 years ago in reply to Jack Bysouth

TI__Guru**** 421650 points

Yes, please re-run the test and post the results. Also post the exact error message you see regarding the memory block error It may also be helpful for our analysis if you could generate a debug server log when you reproduce the error.

Thanks

Processors

Processors forum

TMS320C5515: Issue using XDS110 Debug Probe on CCS v9.3.0