Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] J721S2XSOMXEVM: How to flash Keywriter image over JTAG ?

    Part Number: J721S2XSOMXEVM Tool/software: How to flash Keywriter image over JTAG ?

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62D-Q1 / AM62Px / AM64x / AM243x (ALV) Design Recommendations / Custom board hardware design – POK VMON Voltage Monitor

    Part Number: AM625 Other Parts Discussed in Thread: AM623 , AM6546 , AM6442 , AM2432 , TDA4VH-Q1 , TDA4VH Tool/software: HI TI experts, I have queries related to the voltage monitoring capability of the SOC POK module types, accuracy., design recommendations…

  • [FAQ] PROCESSOR-SDK-AM64X: Create Multicore Appimage using System Project

    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: How to create multicore appimage using the system project ?

  • [FAQ] SK-TDA4VM: How do I set up TFTP and NFS for Linux?

    Part Number: SK-TDA4VM Tool/software: How do I set up tftp and nfs on my host machine to boot Linux on my board?

  • [FAQ] How to read SOC_UID in u-boot on AM6x SoC

    Part Number: AM625 Tool/software: SOC_UID is a device specific identifier calculated by ROM based on "KEK of the device which is unique to every single device, plus other ROM mata-data structure". - unique per SoC and persistent - available on HS…

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62Ax / AM62D-Q1 / AM62Px / AM64x / AM243x (ALV, ALX) Custom board hardware design – JTAG

    Part Number: AM625 Other Parts Discussed in Thread: AM623 , AM2434 , TDA4VM , AM6548 , AM2431 , AM62P5-Q1 , AM62A3-Q1 , TDA4AL-Q1 , TDA4VM-Q1 , TDA4AH-Q1 , MCU-PLUS-SDK-AM243X , SK-AM62A-LP , AM62A7 , TDA4VH-Q1 , AM3358 , SEGGER , AM62P , AM62L , TMS320C6416…

  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…

  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards

  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …

  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.

View FAQ threads
  • Threads 198424 Discussions