TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198107 Discussions
  • Answered

    TDA4VM-Q1: RMII Hardware harness connection 0 Locked

    125 views
    5 replies
    Latest 2 months ago
    by ??? ?
  • Not Answered

    J722SXH01EVM: unable to find PMIC configuration in device tree of TDA4AEN (J722S 10.0 SDK) 0 Locked

    101 views
    5 replies
    Latest 2 months ago
    by Keerthy J
  • Not Answered

    DRA821U-Q1: Is there a way to flash Linux image into eMMC before soldering eMMC to production board? 0 Locked

    91 views
    1 reply
    Latest 2 months ago
    by Gokul Praveen
  • Answered

    J722SXH01EVM: J722SXH01EVM 0 Locked

    51 views
    1 reply
    Latest 2 months ago
    by Tanmay Patil
  • Suggested Answer

    PROCESSOR-SDK-AM62P: TI ARM Clang to Arm GCC 0 Locked

    87 views
    1 reply
    Latest 2 months ago
    by Tushar Thakur
  • Answered

    TDA4VM: Mcasp: How to use uo-dma mode? 0 Locked

    136 views
    7 replies
    Latest 2 months ago
    by Jared McArthur
  • Answered

    AM62A7: Boot through SD Card 0 Locked

    110 views
    2 replies
    Latest 2 months ago
    by Meet Thakar
  • Not Answered

    AM68A: Replacement for MT53E2G32D4DE-046 AUT:C for AM648A custom board 0 Locked

    56 views
    0 replies
    Started 2 months ago
    by Rohith K P
  • Not Answered

    TDA4VH-Q1: I want to know why C7x created new task don't use high address 0 Locked

    84 views
    1 reply
    Latest 2 months ago
    by Shabary S Sundar
  • Not Answered

    SK-AM62P-LP: CAN pin mapping 0 Locked

    76 views
    0 replies
    Started 2 months ago
    by Libin Jose
  • Not Answered

    AM6548: [URGENT] : Clarification Required on Processor Capability for 4-Port Ethernet Communication 0 Locked

    66 views
    1 reply
    Latest 2 months ago
    by Teja Rowthu
  • Answered

    AM62L-PROCESSOR-SDK: GPIO setting / clearing in u-boot 0 Locked

    114 views
    2 replies
    Latest 2 months ago
    by Dheeraj K
  • Not Answered

    TDA4VM: The camera(v4l2) displays the output on linux to CSITX 0 Locked

    936 views
    73 replies
    Latest 2 months ago
    by Adam Hua
  • Not Answered

    AM623: AM623 + TPS6521907 Booting error 0 Locked

    77 views
    2 replies
    Latest 2 months ago
    by ChangHee Park
  • Answered

    TDA4VH-Q1: TIDL-MMALIB: FullyconnectedBias layer - Test case parameters 0 Locked

    225 views
    10 replies
    Latest 2 months ago
    by Khoi Nguyen
  • Answered

    AM6442: Is it possible to do an ethernet loopback test when both eth0 and eth1 are on the CPSW? 0 Locked

    190 views
    4 replies
    Latest 2 months ago
    by Kallikuppa Sreenivasa
  • Suggested Answer

    TDA4VM: Should DSS be handled on RTOS or Linux side in J721E SDK? 0 Locked

    72 views
    1 reply
    Latest 2 months ago
    by Takuma Fujiwara
  • Answered

    TDA4VM-Q1: Configure GPIO interrupt related issues 0 Locked

    514 views
    14 replies
    Latest 2 months ago
    by yanggc
  • Answered

    AM62A7: tiovxdlcolorconvert cannot work with v4l2h264enc 0 Locked

    109 views
    4 replies
    Latest 2 months ago
    by Jason Zeng
  • Answered

    AM62L: GPMC Non-mux mode and Serial SRAM on OSPI 0 Locked

    123 views
    3 replies
    Latest 2 months ago
    by Stanislav Stilyanov
<>