Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: SK-AM69 Other Parts Discussed in Thread: AM69 I followed the steps on Processor SDK Linux for AM69 to boot from OSPI on SK-AM69 and I see the following message upon boot:
U-Boot SPL 2023.04-g756ba776d4 (Jul 13 2023 - 05:36:12 +0000) EEPROM…
Part Number: AM62A7 I’ve just brought up a sensor for AM62A. Now I’m going to start image quality tuning. According to the AM6xA ISP Tuning Guide , the first thing is to set the minimum and maximum exposure time and analog gain for the 2A algorithm…
In customer's current AM6232 design they have to use a heat sink on top of MPU.
A “ThermoPad” is then used between the heat sink and AM6232.
In order for this to work correctly, a certain amount of contact pressure is required.
I don't…
Part Number: AM623
Hi champs!
In customer's current AM6232 design they have to use a heat sink on top of MPU.
A “ThermoPad” is then used between the heat sink and AM6232.
In order for this to work correctly, a certain amount of contact…
Hi TI Experts,
I have the below queries regarding SOC(Processor) power-sequencing requirements for power-up and power-down
1.Is there a recommended power sequence to be followed for power-up? 2.Is there a power supply ramp requirement to be followed…
