TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198113 Discussions
  • Answered

    Virtual channels over CSI2 0 Locked

    695 views
    1 reply
    Latest over 12 years ago
    by Georgi Georgiev XID
  • Not Answered

    Clock to gpmc in OMAP3530 0 Locked

    297 views
    5 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Not Answered

    Measuring clock cycles on C6678 EVM 0 Locked

    361 views
    2 replies
    Latest over 12 years ago
    by Louis Chouinard
  • Not Answered

    SCCB support 0 Locked

    2269 views
    8 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Answered

    About edma3 controller's default burst size of AM387X. 0 Locked

    575 views
    4 replies
    Latest over 12 years ago
    by Hiroki Kato
  • Not Answered

    H264 Encoder freeze at if (Venc1_process(hVe1, hInBuf, hOutBuf) < 0) 0 Locked

    1064 views
    5 replies
    Latest over 12 years ago
    by Yu Song
  • Answered

    Concerto M3 core w/ SYS/BIOS, are web svcs, dhcp, packages available for use w/ SYS/BIOS? 0 Locked

    595 views
    5 replies
    Latest over 12 years ago
    by hongxiang qiu
  • Not Answered

    video_encode_io1_dm365.x470MV freezining 0 Locked

    1476 views
    8 replies
    Latest over 12 years ago
    by Yu Song
  • Not Answered

    Rerun program without "reset". 0 Locked

    244 views
    0 replies
    Started over 12 years ago
    by Mark Moldavsky
  • Answered

    DDR3 settings on C6678 0 Locked

    4924 views
    7 replies
    Latest over 12 years ago
    by Tom Johnson 16214
  • Discussion

    DDR3 PHY Calculation Locked

    1416 views
    15 replies
    Latest over 12 years ago
    by Tom Johnson 16214
  • Answered

    Is there an ERROR on evm816xiodc_Schematics_RevC pin connections? 0 Locked

    1245 views
    16 replies
    Latest over 12 years ago
    by David Soto - RidgeRun
  • Not Answered

    TIM4 on 816X Daughtercard - Video Capture 0 Locked

    462 views
    2 replies
    Latest over 12 years ago
    by David Soto - RidgeRun
  • Not Answered

    linking errors 0 Locked

    189 views
    1 reply
    Latest over 12 years ago
    by lenin t
  • Answered

    CPU loading / memory usage for a specific process in DM8168 0 Locked

    186 views
    1 reply
    Latest over 12 years ago
    by 1330hayacool7102
  • Answered

    Patch file required for using XDS200 emulator with sys/bios (that comes with CCS 5.2) 0 Locked

    204 views
    1 reply
    Latest over 12 years ago
    by Tom Kopriva
  • Answered

    Parameters for task function 0 Locked

    6288 views
    6 replies
    Latest over 12 years ago
    by Tom Kopriva
  • Answered

    AM1808 SPI-Master Multiple Chip-Select Availability? 0 Locked

    396 views
    1 reply
    Latest over 12 years ago
    by Rahul Prabhu
  • Not Answered

    Keystone SPI boot - Parameter Table Index 0 Locked

    1003 views
    2 replies
    Latest over 12 years ago
    by David Meixner
  • Not Answered

    Is 2D accelerated in QT (am3359 vs am3352) 0 Locked

    522 views
    1 reply
    Latest over 12 years ago
    by Dave Gerlach
<>