TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198359 Discussions
  • Answered

    Gingerbread repo sync error 0 Locked

    862 views
    4 replies
    Latest over 12 years ago
    by Simon Yuen
  • Answered

    DM8148 heat sink requirement 0 Locked

    454 views
    1 reply
    Latest over 12 years ago
    by Viet Dinh
  • Not Answered

    Compiling, Building & Running StarterWare example Applications - Failed 0 Locked

    1709 views
    1 reply
    Latest over 12 years ago
    by Carlos Hernandez
  • Answered

    How to measure memory bandwidth and CPU usage on Blaze T2 + 4470? 0 Locked

    549 views
    1 reply
    Latest over 12 years ago
    by Gina Glaser
  • Answered

    Power management for DM814x 0 Locked

    509 views
    5 replies
    Latest over 12 years ago
    by YILMAZ KIRÇİÇEK
  • Not Answered

    Syslink optimized build errors 0 Locked

    333 views
    1 reply
    Latest over 12 years ago
    by Robert Tivy
  • Answered

    OV2720 0 Locked

    701 views
    7 replies
    Latest over 12 years ago
    by Chad Hewitt
  • Answered

    CUSTOM SRESP error with SOURCE:L4CFG 0 Locked

    721 views
    3 replies
    Latest over 12 years ago
    by Alex Trinh
  • Not Answered

    TMDXLCDK6748 - TMS320C6748 DSP Development Kit (LCDK) 0 Locked

    517 views
    2 replies
    Latest over 12 years ago
    by Iyshwarya Gopalakrishnan
  • Not Answered

    ARM processing, Memory_alloc and cache 0 Locked

    215 views
    0 replies
    Started over 12 years ago
    by bandini
  • Not Answered

    Why my program run slower at higher DSP Frequency 0 Locked

    211 views
    1 reply
    Latest over 12 years ago
    by Radhesh Bhat
  • Not Answered

    What is the maximum bit-rates that can be supported by the decoder of DM8148 HDVICP 0 Locked

    286 views
    1 reply
    Latest over 12 years ago
    by Radhesh Bhat
  • Not Answered

    Linux on 335x evm, problem with MMC Sandisk (16 - 32 GB) 0 Locked

    1053 views
    4 replies
    Latest over 12 years ago
    by Filippo Ferrara
  • Answered

    Round Robin for lower priority tasks 0 Locked

    1094 views
    2 replies
    Latest over 12 years ago
    by David Luca
  • Not Answered

    DM365 LCD register settings / Linux Driver 0 Locked

    174 views
    1 reply
    Latest over 12 years ago
    by Renjith Thomas
  • Not Answered

    Is It required to have External Buffer for McASP signals to Audio Codec? 0 Locked

    228 views
    1 reply
    Latest over 12 years ago
    by Biser Gatchev-XID
  • Not Answered

    PROGRAMMING DM368 0 Locked

    167 views
    0 replies
    Started over 12 years ago
    by vyasaraja sosale
  • Answered

    Omapflash script for optimus 3d on a omap 4430 0 Locked

    587 views
    3 replies
    Latest over 12 years ago
    by Gina Glaser
  • Not Answered

    break needed after pushing descriptor to Packet Accelerator(PA)? 0 Locked

    548 views
    3 replies
    Latest over 12 years ago
    by Frank Bauermeister
  • Discussion

    MICREL KSZ9021 not working on am335x MPU. Locked

    722 views
    0 replies
    Started over 12 years ago
    by girish MV
<>