TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197753 Discussions
  • Not Answered

    Hi, We encountered one problem when decode the attached h264 stream using dm368 h264dec( 0 Locked

    179 views
    0 replies
    Started over 13 years ago
    by da lubo
  • Answered

    IPC Notify 0 Locked

    386 views
    1 reply
    Latest over 13 years ago
    by judahvang
  • Answered

    why log_print only only print the former 2 values correctly? 0 Locked

    387 views
    1 reply
    Latest over 13 years ago
    by judahvang
  • Not Answered

    which timer can i use for my application?? 0 Locked

    165 views
    0 replies
    Started over 13 years ago
    by Kalaiyarasan ES
  • Answered

    Using lastest VoLIB 2.0 on C674x problem 0 Locked

    213 views
    1 reply
    Latest over 13 years ago
    by CharlieF
  • Answered

    Can not build DSPLINK for WIN CE 6 for OMAP L138 Experimenter Kit 0 Locked

    380 views
    2 replies
    Latest over 13 years ago
    by Dimitry Denisov
  • Discussion

    NDK: Dropped Raw Ethernet frames with SOCK_RAWETH socket Locked

    6288 views
    29 replies
    Latest over 13 years ago
    by Corey Kasten
  • Answered

    Put u-boot in SPI flash for OMAP-L138 0 Locked

    853 views
    5 replies
    Latest over 13 years ago
    by Mike Looijmans
  • Answered

    C6482 and AET 0 Locked

    641 views
    10 replies
    Latest over 13 years ago
    by turboscrew
  • Answered

    4470 processor board DDR size and frequence? 0 Locked

    575 views
    4 replies
    Latest over 13 years ago
    by Gina Glaser
  • Answered

    Dose anybody have beaglebone Memorymap ?? (not am3359) 0 Locked

    241 views
    2 replies
    Latest over 13 years ago
    by Moonsun Park
  • Not Answered

    Why the bitrate of encoded is the same when rate control of H.264 is VBR or CBR and How to set the VBR/CBR mode on DM8168? 0 Locked

    2121 views
    1 reply
    Latest over 13 years ago
    by Deepak Poddar
  • Not Answered

    SYS/BIOS Project with SRIO and NDK 0 Locked

    758 views
    2 replies
    Latest over 13 years ago
    by Du Fu
  • Not Answered

    MPEG2 Encoder optimization on IVA-HD platform 0 Locked

    226 views
    1 reply
    Latest over 13 years ago
    by Yashwant Dutt
  • Answered

    Need advise on small low cost OMAP board for hobbyist 0 Locked

    239 views
    1 reply
    Latest over 13 years ago
    by Anuj Aggarwal
  • Not Answered

    http://e2e.ti.com/support/embedded/linux/f/354/p/addpost.aspx# 0 Locked

    340 views
    1 reply
    Latest over 13 years ago
    by Prabhakar Lad
  • Answered

    placement fails for objects ".cinit" 0 Locked

    2446 views
    5 replies
    Latest over 13 years ago
    by göksel günlü
  • Not Answered

    USB Device Customization 0 Locked

    114 views
    0 replies
    Started over 13 years ago
    by Joseph Furno
  • Not Answered

    DM365 IPNC 3.0 can't get kernel image! 0 Locked

    732 views
    5 replies
    Latest over 13 years ago
    by mahesh adsul
  • Answered

    Reading data from Emif interface of AM-1808 0 Locked

    327 views
    3 replies
    Latest over 13 years ago
    by 1258021
<>