TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198205 Discussions
  • Not Answered

    How can full HD resolution(1920*1080@30fps) image input on DM3730 0 Locked

    265 views
    0 replies
    Started over 13 years ago
    by Hyunho Shin
  • Not Answered

    error about pvrsrvkm 0 Locked

    627 views
    2 replies
    Latest over 13 years ago
    by free bigfish
  • Not Answered

    rx in omap 3530 0 Locked

    178 views
    2 replies
    Latest over 13 years ago
    by tao wu
  • Answered

    JPEG decode failed 0 Locked

    515 views
    1 reply
    Latest over 13 years ago
    by RSV Prasad
  • Not Answered

    will the DA830 GEL customization spreadsheet work for 'L138? 0 Locked

    126 views
    0 replies
    Started over 13 years ago
    by bowerymarc
  • Answered

    need help on UDP packet sendto 0 Locked

    458 views
    1 reply
    Latest over 13 years ago
    by Brandy Jabkiewicz
  • Not Answered

    How to use the .mptr directive? 0 Locked

    450 views
    1 reply
    Latest over 13 years ago
    by DanRinkes
  • Answered

    Problems in BIOS5 on EVM6472 0 Locked

    724 views
    6 replies
    Latest over 13 years ago
    by Steven Connell
  • Answered

    RTA "like" information 0 Locked

    163 views
    1 reply
    Latest over 13 years ago
    by Steven Connell
  • Not Answered

    C6678 DSP PCIe issue with credits 0 Locked

    902 views
    3 replies
    Latest over 13 years ago
    by Steven Ji
  • Not Answered

    Using I2C to communicate 2 OMAP-L138s 0 Locked

    147 views
    0 replies
    Started over 13 years ago
    by Duy-Ky Nguyen88210
  • Not Answered

    AIF Question 0 Locked

    741 views
    8 replies
    Latest over 13 years ago
    by tscheck
  • Not Answered

    Contact for porting code 0 Locked

    142 views
    0 replies
    Started over 13 years ago
    by std
  • Not Answered

    Code porting service request 0 Locked

    96 views
    0 replies
    Started over 13 years ago
    by std
  • Not Answered

    TMS320C5515 EVM Module's UART & USB are not working? no output seen on the associated PC Pulse Oximeter Application? 0 Locked

    902 views
    4 replies
    Latest over 13 years ago
    by David Ryan
  • Not Answered

    C55 Connected Audio Framework 0 Locked

    204 views
    0 replies
    Started over 13 years ago
    by Chris Saunders
  • Answered

    MSI interrupt works, but only once. 0 Locked

    1030 views
    6 replies
    Latest over 13 years ago
    by Steven Ji
  • Not Answered

    SPI usage by DSP C64x (DM3730) 0 Locked

    364 views
    0 replies
    Started over 13 years ago
    by Sergey Zavyalov
  • Suggested Answer

    SW v1.10.01.01 USB Initialization problem 0 Locked

    1856 views
    11 replies
    Latest over 13 years ago
    by MikeH
  • Not Answered

    TMS320DA828/808 McASP0's Maximum throughput 0 Locked

    302 views
    6 replies
    Latest over 13 years ago
    by Rajarama M Bhat
<>