TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6422: How to Switch Back to External Clock After Clock Loss Detection

    Pratibha Singh
    Pratibha Singh
    Part Number: AM6422 Other Parts Discussed in Thread: AM6442 Tool/software: Hi, I am using the AM6442 Processor Evaluation Kit. We’ve been testing the Clock Loss Detection feature of the AM64x. We provided a 25 MHz external clock to the processor…
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Custom board hardware design – Information on processor core, PLL, VDD_CORE, VDDR_CORE, VPP and other core supplies

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: AM620-Q1 , AM62P , SYSCONFIG , AM625 , AM623 , AM625-Q1 , AM6421 , SK-AM62B-P1 , AM6442 , AM2432 , SK-AM62P-LP Tool/software: Hi TI Experts, Please share your inputs on processor core, thermal…
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Custom board hardware design – Information on PADCONFIG bits and PADCONFIG registers default values summary

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: SYSCONFIG , AM62A3 , AM62P , AM62D-Q1 Tool/software: Hi TI Experts, Could you please elaborate about PADCONFIG register bits and default configurations for PADCONFIG registers.
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design –SD card Interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: AM62P , SYSCONFIG , AM62P5-Q1 , , AM625 , SK-AM62A-LP , AM620-Q1 Tool/software: Hi TI Experts, Is there a list of design recommendations or commonly observed errors for SD card Interface during…
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable constructor / destructor attribute for A53 core using GCC

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I was using the __attribute__((constructor(x) / destructor(y)) property in C code for A53 core with GCC compiler. the GCC attribute is __attribute__((destructor…
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] How to capture TIFS trace with AM62A Linux SDK

    Hong Guan64
    Hong Guan64
    Part Number: AM62A7 Other Parts Discussed in Thread: SK-AM62A-LP Tool/software: TIFS trace log is a useful debug tool to analyze TIFS firmware operations [1] [2]. There's an issue on capturing TIFS trace log from MAIN_UART1 port with AM62A Linux SDK…
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] AM67: How do I enter PCIe TX compliance mode using Linux?

    Takuma Fujiwara
    Takuma Fujiwara
    Part Number: AM67 Tool/software: I would like to do a PCIe compliance test to see if my AM6x PCIe device meets the standards set by PCI-SIG. What is the procedure to run this test?
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
  • [FAQ] DRA821U-Q1: How to enable RGMII2 on CPSW5G for TI EVM using the Native Linux Driver?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: DRA821U-Q1 Tool/software: How can I enable the RGMII2 interface from the CPSW5G Ethernet switch on the DRA821-Q1 TI EVM using the native Linux driver?
    • Answered
    • 3 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198891 Discussions
  • Not Answered

    How to comile dvsdk_demos_3_10_00_16 ; make demos (dm6467) 0 Locked

    478 views
    1 reply
    Latest over 14 years ago
    by yeong yeol Ryu
  • Not Answered

    OMAP-L138+TPS65070 Power Sequence? 0 Locked

    325 views
    1 reply
    Latest over 14 years ago
    by novar luo
  • Not Answered

    Writing a simple Touch screen application 0 Locked

    205 views
    0 replies
    Started over 14 years ago
    by Srinivas C
  • Not Answered

    Problem with simple OpenMAX application 0 Locked

    738 views
    4 replies
    Latest over 14 years ago
    by Piotr Ziecik
  • Answered

    Check the local variables value in run time 0 Locked

    314 views
    4 replies
    Latest over 14 years ago
    by prashant sharana79967
  • Not Answered

    2D FFT float point with c6a8168 and c6accel memory slow 0 Locked

    637 views
    3 replies
    Latest over 14 years ago
    by Patrick Emer
  • Answered

    WinCE booting stops at touch screen calibration on AM/DM37x board 0 Locked

    6913 views
    2 replies
    Latest over 14 years ago
    by Vesper Zhao
  • Not Answered

    How to set the audio Volume of the PMIC TPS65930 0 Locked

    304 views
    1 reply
    Latest over 14 years ago
    by yuliang
  • Answered

    Linux vs. Sys/Bios RTOS 0 Locked

    523 views
    1 reply
    Latest over 14 years ago
    by judahvang
  • Answered

    dvsdk_1_10_00_00 building error 0 Locked

    472 views
    3 replies
    Latest over 14 years ago
    by Madhvi
  • Not Answered

    UPP in DLB mode can't work 0 Locked

    231 views
    1 reply
    Latest over 14 years ago
    by haihua li
  • Answered

    Error while adding the platform package for evmc6678l 0 Locked

    608 views
    1 reply
    Latest over 14 years ago
    by judahvang
  • Not Answered

    L138: Questions on flash writer 0 Locked

    180 views
    1 reply
    Latest over 14 years ago
    by Kiung Chung Wong
  • Not Answered

    Can DM368 support 2*1080P + 1*CIF using V4L2 driver directly? 0 Locked

    548 views
    5 replies
    Latest over 14 years ago
    by Anshuman Saxena
  • Not Answered

    aborts by dumping all the registers 0 Locked

    202 views
    2 replies
    Latest over 14 years ago
    by SANTOSH KUMAR VOONNA
  • Answered

    OMAPL138: missing standard request during USB 2.0 enumeration 0 Locked

    12584 views
    80 replies
    Latest over 14 years ago
    by Kiung Chung Wong
  • Discussion

    wince 6.0 r3 wl1271 TIMM720P Locked

    386 views
    4 replies
    Latest over 14 years ago
    by Atul Verma
  • Not Answered

    How to change resolution dynamically for dm8168? 0 Locked

    153 views
    0 replies
    Started over 14 years ago
    by Jack GunYang
  • Answered

    dvsdk installing problem 0 Locked

    701 views
    4 replies
    Latest over 14 years ago
    by Arseniy Platonov
  • Not Answered

    RBL/UBL & U-Boot interoperability problem when reprogramming in large (4K page) flash 0 Locked

    892 views
    8 replies
    Latest over 14 years ago
    by V.Faul
<>