TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197795 Discussions
  • Answered

    EDMA Configuration - Two Channels, OMAP-L138 0 Locked

    852 views
    4 replies
    Latest over 14 years ago
    by Alexey Tsirlin
  • Answered

    How to use DSPLink? 0 Locked

    371 views
    5 replies
    Latest over 14 years ago
    by Vasil Koshkin
  • Answered

    add DSP support in prebulid AM37X images? 0 Locked

    358 views
    2 replies
    Latest over 14 years ago
    by puyou lu
  • Not Answered

    dm365 u-boot error 0 Locked

    179 views
    0 replies
    Started over 14 years ago
    by ru ying
  • Answered

    Proper setup for dvsdk_1_11_00_00 0 Locked

    528 views
    3 replies
    Latest over 14 years ago
    by wei yang72276
  • Answered

    Help! C6455 SRIO remains Output Error-stopped even write 0x40FC8000 0 Locked

    1221 views
    2 replies
    Latest over 14 years ago
    by Meng Cheng
  • Not Answered

    c5505 interrupt vector table 0 Locked

    652 views
    2 replies
    Latest over 14 years ago
    by seeni vasan
  • Not Answered

    tms320c5505 ezdsp kit 0 Locked

    668 views
    6 replies
    Latest over 14 years ago
    by seeni vasan
  • Not Answered

    DSP access to peripherals - Beagleboard 0 Locked

    327 views
    1 reply
    Latest over 14 years ago
    by Joe Bauman
  • Answered

    Where DM6446 DVSDK 1.30 can be accessable? 0 Locked

    820 views
    5 replies
    Latest over 14 years ago
    by rchen
  • Answered

    make decode example in dvsdk 0 Locked

    407 views
    1 reply
    Latest over 14 years ago
    by Kurorido ROliroli
  • Not Answered

    OMAP 3530 Booting from Serial cable 0 Locked

    199 views
    0 replies
    Started over 14 years ago
    by narasimha reddy72258
  • Not Answered

    DSPLink + image algorithm 0 Locked

    136 views
    1 reply
    Latest over 14 years ago
    by Vasil Koshkin
  • Answered

    DMVA2IPNC booting problem... 0 Locked

    3814 views
    50 replies
    Latest over 14 years ago
    by umair khan
  • Not Answered

    Live Image processing with CCS 0 Locked

    453 views
    2 replies
    Latest over 14 years ago
    by RandyP
  • Not Answered

    line number miss? 0 Locked

    207 views
    1 reply
    Latest over 14 years ago
    by Nagabhushana
  • Suggested Answer

    Run two separate combo (x64P) in single board 0 Locked

    249 views
    1 reply
    Latest over 14 years ago
    by Chris Ring
  • Not Answered

    Gstreamer filesink issue 0 Locked

    266 views
    0 replies
    Started over 14 years ago
    by Sean Preston
  • Suggested Answer

    Suggestion required regarding EMU Debug 0 Locked

    211 views
    1 reply
    Latest over 14 years ago
    by BrandonAzbell
  • Answered

    MessageQ messages 0 Locked

    583 views
    1 reply
    Latest over 14 years ago
    by ToddMullanix
<>