TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM69A: BOOTING FROM EMMC WITHOUT SD CARD

    Gokul Praveen
    Gokul Praveen
    Part Number: AM69A Other Parts Discussed in Thread: AM69 Tool/software: How to boot from eMMC without SD card?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Undeclared Identifier for MCU GPIO Interrupt Routers

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I am trying to upgrade my project to use the new MCU+ SDK 10.1 and I'm running into a compilation error saying that the interrupt router number is undeclared. This…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x (ALV) / AM335x Design Recommendations / Custom board hardware design - Schematics review checklists

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62L Tool/software: Hi Board designers The AM64x, AM62x, AM62Ax, AM62D-Q1, AM62Px and AM62L custom board Schematic review Checklist application note provides a supplemental design check…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: Deploy MMYOLO on AM62A, YOLOV8 nano as example.

    Adam Hua
    Adam Hua
    Part Number: AM62A7-Q1 Tool/software: MMYOLO is an open source repo for quick yolo model evaluation. Deployment MMYOLO on TI processor like AM6x or TDAx requires some modifications on this repo. This FAQ uses yolov8 as example to demonstrate how to…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to SysConfig-PinMux IOSET and Voltage Conflict

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Tool/software: Hi TI Experts, I see IOSET option and Voltage Conflict indication while using SysConfig-PinMux. Can you provide additional inputs on the IOSET and Voltage configuration
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Incorrect auto-generated MAC port 2 PHY configuration

    Nitika Verma
    Nitika Verma
    Part Number: SK-AM64B Other Parts Discussed in Thread: DP83869 , SYSCONFIG Tool/software: The two Ethernet Ports on SK-AM64x are connected to two separate Gigabit Ethernet PHY Transceivers DP83867. On enabling MAC Port 2 in SK-AM64x networking…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to passive components values, tolerance, voltage rating

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, 1. In the SK/EVM i see 49.9K resistor used. Can i use a standard value instead 2. In the SK/EVM i see a number of resistors used with 1% tolerance for pullups and series resistors. Can i use standard…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design – Queries related to Residual Voltage, Detection and supply decay

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6594-Q1 , AM62P Tool/software: HI TI experts, I have the below queries related to residual voltage 1. What are the causes for Residual Voltage 2. Effect of Residual Voltage on…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: SDIO driver strength change

    Biao Li
    Biao Li
    Part Number: AM62A7-Q1 Other Parts Discussed in Thread: AM62A7 Tool/software: Hi Expert, Customer was doing EMC test, it was found that the EMMC CLOCK exceeded the standard by 10dB at 1.8GHz and 1.6GHz. Can the output strength capability of the…
    • 9 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198418 Discussions
  • Not Answered

    5510 HPI download 0 Locked

    252 views
    1 reply
    Latest over 14 years ago
    by TommyG
  • Suggested Answer

    C6Run for WinCE? 0 Locked

    268 views
    2 replies
    Latest over 14 years ago
    by Rahul Prabhu
  • Not Answered

    5509A - DMA_DMACCR_EN_STOP/START 0 Locked

    193 views
    1 reply
    Latest over 14 years ago
    by TommyG
  • Not Answered

    Is DaVinci good for this project? 0 Locked

    635 views
    11 replies
    Latest over 14 years ago
    by Paul.Yin
  • Answered

    How OMAP-L138 assign peripherals to ARM or DSP? 0 Locked

    519 views
    5 replies
    Latest over 14 years ago
    by tlee
  • Not Answered

    Basic Code Composer project for 5510a 0 Locked

    344 views
    3 replies
    Latest over 14 years ago
    by TommyG
  • Answered

    configuration of hardware interruprs (HWI) and DSP/BIOS 5.41 0 Locked

    284 views
    1 reply
    Latest over 14 years ago
    by TommyG
  • Answered

    DM6437 0 Locked

    268 views
    6 replies
    Latest over 14 years ago
    by Marcio
  • Not Answered

    C5515 DMA interface with ADC. 0 Locked

    365 views
    1 reply
    Latest over 14 years ago
    by TommyG
  • Not Answered

    compiler error message problem? 0 Locked

    124 views
    1 reply
    Latest over 14 years ago
    by MattLipsey
  • Not Answered

    jffs2 inconsistent lock state 0 Locked

    317 views
    0 replies
    Started over 14 years ago
    by Woody Douglass
  • Not Answered

    USB, Ethernet, RS-232 (UART) without Linux 0 Locked

    210 views
    1 reply
    Latest over 14 years ago
    by swami
  • Not Answered

    DM368 UBL source code 0 Locked

    696 views
    1 reply
    Latest over 14 years ago
    by Sonia Ghelani
  • Answered

    jffs2 ECC errors 0 Locked

    3074 views
    4 replies
    Latest over 14 years ago
    by paulb
  • Not Answered

    Reg: Resizer look like zoomed 0 Locked

    158 views
    0 replies
    Started over 14 years ago
    by Salim
  • Answered

    Continous SPI Communication via EDMA controlled by Spix_ENA line 0 Locked

    1706 views
    10 replies
    Latest over 14 years ago
    by Zhengting He
  • Not Answered

    video playing on leopard dm355 board 0 Locked

    421 views
    4 replies
    Latest over 14 years ago
    by Jeff Hayes
  • Not Answered

    LCD output and non-standard mode 0 Locked

    430 views
    7 replies
    Latest over 14 years ago
    by Isara
  • Answered

    Building GStreamer, where should ZLIB be? 0 Locked

    1907 views
    11 replies
    Latest over 14 years ago
    by Wesley Miller
  • Answered

    c6747 sd_card interface 0 Locked

    164 views
    2 replies
    Latest over 14 years ago
    by guzin kurnaz
<>