TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198112 Discussions
  • Suggested Answer

    What is the address of EM_BA[1] of DM355 using the 16bit mode? 0 Locked

    410 views
    2 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    A cheap way to develop for DM355 Locked

    884 views
    10 replies
    Latest over 16 years ago
    by Harshad Chirutkar
  • Suggested Answer

    DM648 NDK 0 Locked

    239 views
    1 reply
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    getting linker to provide offset for relative assembly branch 0 Locked

    190 views
    1 reply
    Latest over 16 years ago
    by MattLipsey
  • Not Answered

    [OMAP3530] Is source available for lpmON.* and lpmOFF.* ? 0 Locked

    271 views
    0 replies
    Started over 16 years ago
    by Chris Norris
  • Discussion

    problem loading DVSDK jffs and uImage obtained by recompiling Locked

    228 views
    1 reply
    Latest over 16 years ago
    by wpl
  • Answered

    DM648 Video Port Revisited.... 0 Locked

    289 views
    1 reply
    Latest over 16 years ago
    by JRasmussen
  • Not Answered

    Update the SDK component 0 Locked

    174 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    about ndk??? 0 Locked

    392 views
    5 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    Code Compilation - Timing Problems 0 Locked

    171 views
    1 reply
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    [C6713] Analog Output Question Locked

    2566 views
    23 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    EDMA in the DSP side codec.. 0 Locked

    243 views
    2 replies
    Latest over 16 years ago
    by Gunjan
  • Not Answered

    Make XDAIS sample work with codec engine 0 Locked

    256 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    bom needed for c54cst 0 Locked

    297 views
    1 reply
    Latest over 16 years ago
    by TommyG
  • Answered

    How do I read VERSION? 0 Locked

    480 views
    5 replies
    Latest over 16 years ago
    by j p
  • Not Answered

    CCS slowdown when reloading with register windows displayed 0 Locked

    218 views
    2 replies
    Latest over 16 years ago
    by MattLipsey
  • Not Answered

    H264 on DM6446 testing 0 Locked

    185 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    How to access pixels in a frame on DM6446 0 Locked

    289 views
    3 replies
    Latest over 16 years ago
    by LorryAstra
  • Answered

    how to manually map c64+ interrupt service routines 0 Locked

    321 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    request for help... it is very urgent...please help.... 0 Locked

    647 views
    6 replies
    Latest over 16 years ago
    by MANIKANDAN NAGARAJAN
<>