TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197753 Discussions
  • Not Answered

    AM335x: gpio control in u-boot and kernel 0 Locked

    1473 views
    2 replies
    Latest over 9 years ago
    by jeremie.vassoille
  • Answered

    Real time digital signal processing and it's performance analysis 0 Locked

    841 views
    3 replies
    Latest over 9 years ago
    by Robert Tivy
  • Answered

    Interfacing with TMS320C5535 EZDSP 0 Locked

    721 views
    1 reply
    Latest over 9 years ago
    by Lalindra Jayatilleke
  • Suggested Answer

    Unable to Run PWMSS0, PWMSS1, and PWMSS2 from PRU on Beagle Bone Black. 0 Locked

    4024 views
    16 replies
    Latest over 9 years ago
    by Michael Brainerd
  • Answered

    ICE AM3359 v2 - Beginner Questions 0 Locked

    1112 views
    4 replies
    Latest over 9 years ago
    by Nicola De Lellis
  • Answered

    SPI1_D1 sys_bios reading a value of 255 (0xFF) all the time 0 Locked

    1103 views
    5 replies
    Latest over 9 years ago
    by ToddMullanix
  • Answered

    Is it possible to write pure assembly code for remoteproc? 0 Locked

    1149 views
    5 replies
    Latest over 9 years ago
    by Nicolas Dammin
  • Not Answered

    Build process break with "Debug/configPkg/package/cfg/SMARTrode_pe430X.h" not found message after recent update 0 Locked

    474 views
    4 replies
    Latest over 9 years ago
    by Vikram Adiga
  • Suggested Answer

    Trying to debug u-boot with XDS100v2 on am3352: Target must be connected before loading program 0 Locked

    703 views
    5 replies
    Latest over 9 years ago
    by Joe G.
  • Suggested Answer

    What are the min, max, typ specifications (rise time, duty cycle and jitter, etc.) of the output clocks of the Sitara AM57xx processors ?? 0 Locked

    170 views
    1 reply
    Latest over 9 years ago
    by Biser Gatchev-XID
  • Answered

    AM437x whole decoupling capacitors in top layer 0 Locked

    228 views
    1 reply
    Latest over 9 years ago
    by Biser Gatchev-XID
  • Suggested Answer

    AM5728 Power Spreadsheet and Thermal Measurements 0 Locked

    513 views
    3 replies
    Latest over 9 years ago
    by Ritesh Parekh
  • Suggested Answer

    Sitara Linux Program the eMMC on Beaglebone Black 0 Locked

    1302 views
    9 replies
    Latest over 9 years ago
    by Jitheesh T
  • Not Answered

    TMS320DM8168CCYGA2 Mechanical Support 0 Locked

    572 views
    1 reply
    Latest over 9 years ago
    by Pavel Botev
  • Suggested Answer

    how to allocate am335x DMA channel to SPI 0 Locked

    2276 views
    4 replies
    Latest over 9 years ago
    by Yordan Kovachev
  • Answered

    IQMath and negative zero 0 Locked

    554 views
    3 replies
    Latest over 9 years ago
    by 1970135
  • Answered

    Are external 10k pullups neccesary on MMC1 data/command lines when connected to eMMC device? 0 Locked

    4896 views
    19 replies
    Latest over 9 years ago
    by jln007
  • Answered

    RTOS for Starterware on a BeagleBone 0 Locked

    749 views
    1 reply
    Latest over 9 years ago
    by Lalindra Jayatilleke
  • Suggested Answer

    AM437x error message "drm:omap_plane_error_irq" 0 Locked

    1853 views
    6 replies
    Latest over 9 years ago
    by Yordan Kovachev
  • Answered

    Mixed Language Makefile for Syslink example 0 Locked

    1070 views
    4 replies
    Latest over 9 years ago
    by Shankari G
<>