Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM620-Q1
Tool/software:
In one of our projects, we are using AM620-Q1_FCBGA441 where there is a necessity of DDR4 interface.
We need help from Texas side for the following details for signal integrity simulation:
1. on-die package…
Part Number: AM6421 Other Parts Discussed in Thread: SYSCONFIG , AM6442 , , AM6422 , TMDS64EVM , SK-AM64B
Tool/software:
Hello,
I found some issues when debugging MCSPI – FRAM. Please help give solutions to resolve these issues, thanks.
Currently…
Part Number: AM62A7 Other Parts Discussed in Thread: AM62P , AM69A , AM68A , AM67 , , AM625 , AM623
Tool/software:
What are the most common problems encountered when developing camera applications on the AM6x (AM62/AM62A/AM62P/AM67/AM68A/AM69A) and…
Part Number: AM62A7 Other Parts Discussed in Thread: AM67 ,
Tool/software:
I connected my CSI camera to my board and the sensor has successfully probed, but I'm not able to capture images from the camera. None of "v4l2-ctl --stream-mmap", "yavta -c…
Part Number: AM62A7 Other Parts Discussed in Thread: AM62P , , AM67 , AM625 , AM623
Tool/software:
I connected my CSI camera to my board, but the sensor didn't probe. What are the possible reasons the sensor doesn't probe?
Other parts: AM62A3 ,…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP
Tool/software:
AM62x boot rom supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0 compatible…
Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM
Tool/software:
Hi Customer,
This FAQ will introduce the detail steps for different SDK in SBL or SPL.
BR,
Biao
Part Number: AM62A7
Tool/software:
I connected a sensor to my AM62A starter kit EVM, and the sensor correctly probed. When I did "v4l2-ctl --list-devices", many "/dev/videoX" nodes were listed. Which one should be used to capture images from the sensor…
Part Number: AM62A7
Tool/software:
I want to use v4l2-ctl to change sensor parameters at run time, but the command "v4l2-ctl -d /dev/videoX --list-ctrls" returns nothing. What's the right command?
