TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot u-boot from parallel GPMC NAND on AM64x

    Hong Guan64
    Hong Guan64
    Part Number: AM6442 Other Parts Discussed in Thread: TMDS64EVM Tool/software: AM64x boot ROM supports booting from parallel GPMC NAND. From "4.4.10 GPMC NAND Boot" in AM64x TRM "AM64x ROM only supports boot from ONFI 1.0 compatible 8 bit parallel…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198502 Discussions
  • Not Answered

    [DM814x ] Frame rate of Vpss M3 drops after enabling Video M3 0 Locked

    449 views
    2 replies
    Latest over 10 years ago
    by Ri-Ping YU
  • Not Answered

    Checking state of DIP swich using interrupts 0 Locked

    501 views
    1 reply
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Suggested Answer

    library search path 0 Locked

    543 views
    3 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    How can i run QualiTI? 0 Locked

    406 views
    3 replies
    Latest over 10 years ago
    by Senthilkumar Srinivasan
  • Not Answered

    am335x Overheated 0 Locked

    313 views
    4 replies
    Latest over 10 years ago
    by Brad Griffis
  • Not Answered

    am335x i2c, there is no any waveform at sda and scl. 0 Locked

    3316 views
    15 replies
    Latest over 10 years ago
    by Brad Griffis
  • Discussion

    Interfacing eMMC Memory with OMAP4460 Locked

    1251 views
    5 replies
    Latest over 10 years ago
    by Yanko Todorov-XID
  • Not Answered

    Clarification on OMAP4 GPMC burst write 0 Locked

    899 views
    3 replies
    Latest over 10 years ago
    by Yordan Kovachev
  • Answered

    How can add Dra7xx device in CCS v5.4? 0 Locked

    1232 views
    3 replies
    Latest over 10 years ago
    by Yuanfeng Tan
  • Not Answered

    How to detect high moving content 0 Locked

    228 views
    0 replies
    Started over 10 years ago
    by hb chen
  • Not Answered

    C5535 ezdsp watchdog timer work unstable 0 Locked

    498 views
    2 replies
    Latest over 10 years ago
    by Will Lin1
  • Not Answered

    How to analyze decode debug trace log on TI8168 IVAHD? 0 Locked

    591 views
    1 reply
    Latest over 10 years ago
    by Mohd. Harris
  • Answered

    Issues with Empia + saa7115 on BBB 0 Locked

    529 views
    2 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    SYS/BIOS large data allocation 0 Locked

    4504 views
    17 replies
    Latest over 10 years ago
    by Christoph Obrecht
  • Answered

    Arago build failure on da850-omapl138-evm 0 Locked

    6988 views
    23 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    Complet linux image on ZedBoard? 0 Locked

    337 views
    2 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    spi device debugging 0 Locked

    2568 views
    10 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    Recognition using HOG from VLIB 0 Locked

    570 views
    2 replies
    Latest over 10 years ago
    by kenshow
  • Answered

    C5515 vs C5517 0 Locked

    512 views
    2 replies
    Latest over 10 years ago
    by MikeH
  • Not Answered

    DDR3 clock speed is not maxed to 400Mhz 0 Locked

    841 views
    4 replies
    Latest over 10 years ago
    by Carsten Hansen
<>